TonyM's user avatar
TonyM's user avatar
TonyM's user avatar
TonyM
  • Member for 7 years, 9 months
  • Last seen this week
  • UK
11 votes
Accepted

What does the FPGA do with unreferenced I/O pins?

11 votes

How could I connect a PDIP8 PIC controller to a PCB so I could remove it?

9 votes

I2C to 100+ PWM

9 votes

Is there ever any reason to prefer 5% tolerance resistors over 1%?

9 votes

What do you call this kind of cable?

9 votes
Accepted

How to tell a DC Motor is stuck?

9 votes
Accepted

16MHz Crystal trace length

9 votes

How do I efficiently search for ICs?

9 votes

What is the main difference between a decoder and a demultiplexer

9 votes

What is the difference between a USB port and a USB receptacle?

9 votes

Why can't an MCU's GPIO pins directly control power MOSFETs?

8 votes
Accepted

What are the "redundant bytes" added to every page of this NAND flash?

8 votes

How can I see if my oscillator works without using an oscilloscope?

8 votes

Scam? Does having this capacitor wired as shown provide any surge protection?

8 votes
Accepted

Component ratings amps or watts?

8 votes

Can an op-amp's Vin+ and Vin- be outside the supply voltage as long as their difference is inside it?

8 votes
Accepted

Is it possible to know the instantiation number inside the instantiated code when using a for loop to generate multiple VHDL component instances?

8 votes

What is the simplest way to invert a signal with just one jumper?

8 votes
Accepted

Understanding difference between Interrupt Address and interrupt vector address

8 votes

Problem with capacitor after bridge rectifier

8 votes

Why using a power adaptor with mismatched current rating will not damage an electronic device?

8 votes

Looking for a device to "pass through" or "make high impedance" 8 bits based on one control bit

8 votes

Thick line with square brackets on schematic

7 votes
Accepted

Switching HV DC relay on crashes microcontroller

7 votes

Simplest, cheapest, fast and minimum footprint current limiting circuit with low resistance in normal state

7 votes

NUL character in an ASCII-Based protocol over UART

7 votes

Is there an ideal PWM frequency for DC brush motors?

7 votes
Accepted

Help me evaluate this time-delay circuit

7 votes

Doubt regarding SR latch

6 votes

How to protect a power supply

1
2
3 4 5
22