tuskiomi's user avatar
tuskiomi's user avatar
tuskiomi's user avatar
tuskiomi
  • Member for 7 years, 1 month
  • Last seen this week
  • N/a
  • Minneapolis, MN, United States
6 votes
3 answers
3k views

My first AVR C program- LED not blinking

6 votes
4 answers
340 views

Why do we use the terms AC and DC if they have nothing to do with current?

3 votes
3 answers
2k views

What is the difference between electrical engineering and electrical engineering technology? [closed]

2 votes
2 answers
547 views

OP-AMP RC multivibrator not producing a sine wave across capacitor.

2 votes
1 answer
207 views

What is the difference between a low end and a high end rework station, and why pay for a higher end station? [closed]

2 votes
2 answers
395 views

what is an "Adressable" I2c device, and what does it mean?

2 votes
1 answer
473 views

Alternatives to stacked iron plates for electric motor cores?

2 votes
1 answer
74 views

Why does the Datasheet for the ATMEGA88 have two pins for PORT D bit 5 (with different functions, too)?

1 vote
0 answers
74 views

How effective is using a LQFP type breakout board to test microprocessors?

1 vote
1 answer
236 views

controlling many LEDs on an individual basis

1 vote
1 answer
414 views

Can a single bjt PNP be an or gate?

1 vote
2 answers
3k views

A Lipo battery protection circuit

1 vote
1 answer
204 views

Vivado cannot determine equality operator for enum type in assert statement

1 vote
1 answer
153 views

Should a 5V wall adapter output 150V pk-pk AC relative to earth?

1 vote
1 answer
138 views

Is this the correct truth table to determine whether or not to execute an interrupt in a RISC V system?

0 votes
2 answers
201 views

What are common ways that modern processors handle data hazards with asynchronous registers

0 votes
2 answers
1k views

Will connecting a NEMA 14-50 to a IEC 60320-C13 in this manner present issues

0 votes
1 answer
2k views

What are good resistance values for stepper motors?

0 votes
1 answer
302 views

What type of 4-pin 1mm-pitch clippy connector is this?

0 votes
1 answer
257 views

Measuring minute resistances with low-power usage?

0 votes
2 answers
195 views

How practical are Test Sockets?

0 votes
0 answers
77 views

I've gotten an oscilloscope! How do I take care of it? [duplicate]

0 votes
1 answer
1k views

What is sensor radius?

0 votes
1 answer
1k views

The accuracy of Force Sensitive Resistors (FSRs)

0 votes
2 answers
163 views

Is the following N-FET circuit sufficient to act as a power switch for an IC?

0 votes
0 answers
60 views

Which implementation of a safety stop is more accurate?

0 votes
2 answers
291 views

How do I find the proper transfer function of this passive filter?

0 votes
0 answers
78 views

Will the following ATSAMD21 series code properly configure SysTick interrupt?

0 votes
3 answers
175 views

Why is vivado so wasteful with its D-flipflop placement?

0 votes
0 answers
22 views

Given a constant R,C, and the input voltage at any time, what is the output of a low pass rc circuit?