user avatar
user avatar
user avatar
vofa
  • Member for 5 years, 8 months
  • Last seen this week
9 votes

What does N/F mean on the resistors?

9 votes
Accepted

What design should I use to clean up this pulse wave?

6 votes

LC Low pass filter in LTSpice

6 votes
Accepted

What is this glue?

5 votes
Accepted

How to extend a connected graphic lines in KiCad 6?

4 votes
Accepted

Controlling PWM with an external oscillator and a JFET

4 votes

Solution to replace TLC2272CP IC

4 votes

How to set up 40 hz flashing LED lights to light a room?

4 votes
Accepted

Using an earth bonding plug for grounding server rack enclosure

3 votes

cable size vs current rating

3 votes
Accepted

Microphone peak detector circuit no signal response

3 votes

Which transistor should I use in my circuit?

3 votes

How to understand electronic circuits?

3 votes
Accepted

minimum trace spacing error

3 votes

neat voltage divide sequence

3 votes

Where to include Stomp Switch on this Boost Pedal Schematic?

3 votes
Accepted

Determining V and I from limited data

3 votes
Accepted

SMD transistor marking

3 votes
Accepted

LM358 hot to the touch without any load

3 votes

Are the two resistors R1 and R2 in parallel?

3 votes

Calculating current for a parallel array of in-series LEDs

2 votes
Accepted

Oscilloscope "noise"?

2 votes
Accepted

LM3466 circuit symbols, SEN/SRC to ground?

2 votes
Accepted

How can I connect this LED

2 votes
Accepted

Patient protection in a biopotential amplifier

2 votes

Why is it "Vactrols" are not commonly used?

2 votes

I cant seem to figure out FCC or any testing for that matter

2 votes
Accepted

How is a 'ribbon controller' called in electrical terms?

2 votes

Anti-static mat connected to earth directly or 1E6 ohm resistor?

2 votes
Accepted

When do I choose to use a rosin based flux or rosin-free flux?