Jay Carlson's user avatar
Jay Carlson's user avatar
Jay Carlson's user avatar
Jay Carlson
  • Member for 11 years, 5 months
  • Last seen more than a week ago
99 votes
Accepted

230V AC to 5V DC converter, lossless

19 votes
Accepted

What does N/F mean on the resistors?

14 votes
Accepted

What would make me choose Verilog or VHDL over schematic design on CPLDs or FPGAs?

10 votes
Accepted

Meaning of crossed wires in schematic

7 votes
Accepted

How to feed an SPI TFT display a signal from a composite video source

6 votes

How would I condition the signal from an accelerometer for a microphone input?

6 votes
Accepted

Name this short-range optical component

6 votes
Accepted

Voltage Divider Circuit Question

5 votes
Accepted

Why does the voltage changes in this simple circuit?

4 votes

FPGA development kit for beginners , Spartan6 or Spartan3?

4 votes

How to measure phase difference of two signals of the same frequency in an FPGA?

3 votes

Tuning the radio receiver

3 votes

Best way to wirelessly transmit and receive data

3 votes

Control strong DC motor with microcontroller

3 votes

Is there a difference in heat produced on a conductor between AC and DC at the same amperage and voltage?

3 votes

Building an RSSI map for an indoor positioning system

3 votes

MCP 23018/23S18 for LED and Switch control

3 votes

3V MCU pin to gate a 5V pfet?

2 votes
Accepted

Wiring a high voltage transformer

2 votes
Accepted

Dynamic switching of radio: Change between wireless protocols in the 2.4GHz

2 votes

GPS signal strength issue - route layout problem?

2 votes
Accepted

How do you wire up the OV3640 camera module?

2 votes

Serial Over IP or USB over IP?

2 votes
Accepted

Is it possible to replace a CC2500 with a CC2531?

2 votes

Building a 3D IR scanner with USB power

2 votes

USB to TTL (CH340G) and maybe Logic level converter to program chips

2 votes

Can someone help me understand this H-Bridge?

2 votes

Floating point ADC

2 votes

Test Cases for 16-bit Ripple Carry Adder

1 vote

Which of these marks signifies Pin 1 on the STM32F (LQFP64)?