User Entrepreneur

4 votes

will a battery drain charge if connected to a breadboard open circuit and no load

answered May 28, 2017 at 8:20

3 votes

Accepted

PIC24FJ256DA210 issues with UART Receive, U1STAbits.URXDA never changes AND interrupt never triggers

answered Jun 23, 2017 at 18:26

3 votes

How to create a counter to display 6 digits using anodes?

answered May 16, 2017 at 2:52

3 votes

Accepted

Reading/Writing An SRAM Chip with an Arduino

answered May 20, 2017 at 13:34

3 votes

LM741 op-amp, converting positive output to negative

answered Aug 12, 2017 at 0:28

2 votes

Little confuse about the truth table about D-flip flop

answered Sep 15, 2017 at 15:38

2 votes

Is there a way to change only one of the outputs of a D flip-flop?

answered Sep 17, 2017 at 15:21

2 votes

4 Wire Strain Gauge to 2 Wire Conversion/Connection

answered May 19, 2017 at 16:34

2 votes

decreasing the range of an lnfrared emitter

answered Jul 13, 2017 at 21:11

1 vote

SPI Bus Routing: Signal Integrity Issue?

answered Aug 4, 2017 at 0:43

1 vote

Closed loop PMDC motor control

answered Jun 7, 2017 at 23:26

1 vote

How to Design a combinational circuit using a suitable decoder and OR gate

answered Jun 17, 2017 at 13:25

1 vote

Center tap transformer with full bridge rectifier, number of rectifiers

answered Jun 19, 2017 at 19:38

1 vote

74181 ALU not working properly cascaded to add 8 bit numbers

answered Jun 22, 2017 at 0:35

1 vote

If the clock and D input of a D flipflop are shorted and clock connected to this circuit, how will it respond?

answered Jun 22, 2017 at 15:31

1 vote

How to Power Motor From Alarm

answered May 23, 2017 at 14:20

1 vote

Accepted

scrambled uart output

answered May 25, 2017 at 3:17

1 vote

Comparator Design

answered May 25, 2017 at 20:40

1 vote

Maximum Current Input for 555

answered May 19, 2017 at 11:27

1 vote

getting rid of dc offset at input of unity gain difference amplifier

answered May 12, 2017 at 17:13

1 vote

Help using MUX in Logisim

answered May 21, 2017 at 12:58

1 vote

Very simple CPU design in LogiSim

answered May 21, 2017 at 19:53

1 vote

Encoder too fast for a poor Atmega328?

answered May 16, 2017 at 17:17

1 vote

where to insert a thermocouple simulator in a circuit?

answered May 18, 2017 at 10:57

1 vote

How to make LED flash once every 5 seconds using using 555 timer?

answered Sep 21, 2017 at 0:46

1 vote

Water Sensing Circuit

answered Oct 23, 2017 at 17:11

0 votes

Single rotation DC motor using 3 bit binary counter

answered Oct 26, 2017 at 12:59

0 votes

How to represent Negative real numbers in Fixed Point representation

answered Nov 1, 2017 at 22:18

0 votes

Opamp outputs high DC finite voltage when input signal is low

answered Aug 16, 2017 at 3:00

0 votes

how to create a circuit to represent x^2 +2?

answered Oct 9, 2017 at 16:27

Stack Exchange Network

46 Answers

will a battery drain charge if connected to a breadboard open circuit and no load

PIC24FJ256DA210 issues with UART Receive, U1STAbits.URXDA never changes AND interrupt never triggers

How to create a counter to display 6 digits using anodes?

Reading/Writing An SRAM Chip with an Arduino

LM741 op-amp, converting positive output to negative

Little confuse about the truth table about D-flip flop

Is there a way to change only one of the outputs of a D flip-flop?

4 Wire Strain Gauge to 2 Wire Conversion/Connection

decreasing the range of an lnfrared emitter

SPI Bus Routing: Signal Integrity Issue?

Closed loop PMDC motor control

How to Design a combinational circuit using a suitable decoder and OR gate

Center tap transformer with full bridge rectifier, number of rectifiers

74181 ALU not working properly cascaded to add 8 bit numbers

If the clock and D input of a D flipflop are shorted and clock connected to this circuit, how will it respond?

How to Power Motor From Alarm

scrambled uart output

Comparator Design

Maximum Current Input for 555

getting rid of dc offset at input of unity gain difference amplifier

Help using MUX in Logisim

Very simple CPU design in LogiSim

Encoder too fast for a poor Atmega328?

where to insert a thermocouple simulator in a circuit?

How to make LED flash once every 5 seconds using using 555 timer?

Water Sensing Circuit

Single rotation DC motor using 3 bit binary counter

How to represent Negative real numbers in Fixed Point representation

Opamp outputs high DC finite voltage when input signal is low

how to create a circuit to represent x^2 +2?