As of May 31, 2023, we have updated our Code of Conduct.
Elmesito's user avatar
Elmesito's user avatar
Elmesito's user avatar
Elmesito
  • Member for 5 years, 10 months
  • Last seen more than 3 years ago
  • Europe
15 votes
Accepted

PCB stackup for an 8-layer PCB

11 votes

How to remove these lines in Altium Design

10 votes
Accepted

‘One for all’ standardized land pattern v.s. specified land pattern in datasheet

8 votes

Beginner's second PCB circuit design: AC to DC

6 votes
Accepted

What are these connectors called? (Often found inside of Smartphones)

6 votes
Accepted

Water level indicator using ULN2803

6 votes
Accepted

ULQ2003 not driving a Relay properly

6 votes
Accepted

Looking for a way to re-program 16x2 LCD display EEPROM font

5 votes

TO-247 High Voltage pin clearance

4 votes
Accepted

Identify part orientation

4 votes
Accepted

I am trying to PCB using a schematic I made

4 votes

Pastemask for through hole components

4 votes

Keep out zone of microSD card set footprint

4 votes

Converting a wireless mouse into a wired mouse

3 votes
Accepted

Identification of 6-pin chip marked W134H?

3 votes

How do I design my own FFC cable

3 votes

Why are devices like the MCP23008 or PCF8574 still around when cheaper alternatives exist?

3 votes
Accepted

Programming esp8266 NodeMCU (with Arduino IDE)

3 votes
Accepted

Is this possible to make a module with both castellations and LGA?

3 votes

Is there a PCB coplanar edge connector made for high power transmission instead of data transmission?

3 votes

What to expect when sourcing parts

3 votes
Accepted

Powering 30m of RGB LED strips?

3 votes

bike won't start until rider wear helmet

3 votes

I2C bus isolation for dummies

3 votes

PCB stackup ambigous percent number

2 votes
Accepted

Routing traces over traces in two layer pcb

2 votes
Accepted

Resistor calculator to get close to a final value?

2 votes
Accepted

Why use marks on the PCB solder layer?

2 votes

Is RoHS and EMC compliance enough for a 24V industrial sensor to carry CE Mark?

2 votes

Why do engineers usually short ground and negative ports on a DC power supply?