Skip to main content
Selvek's user avatar
Selvek's user avatar
Selvek's user avatar
Selvek
  • Member for 6 years, 4 months
  • Last seen more than a month ago
  • Colorado
9 votes

Is the formula for inductive reactance the same when considering rectified AC?

9 votes

In a flyback transformer with multiple windings, how are voltages controlled for different current loads?

7 votes
Accepted

LTspice gives wrong AC analysis

7 votes

PCB design rules

7 votes
Accepted

The S parameters of an attenuator--but what is actually wrong with it?

5 votes
Accepted

LVDS Flex Cables - Optimizing Trace Layout for 10 GbE

5 votes
Accepted

Linear and non-linear attenuator

4 votes
Accepted

Basic: Current flow and grounding

4 votes
Accepted

Impedance matching: L-network or micro strips?

4 votes
Accepted

LED indicators for 2 Positive voltages and 1 Negative

4 votes

What effect does having a constant +12V on the drain have on an N-channel MOSFET?

3 votes
Accepted

Are multiple groundplanes a good idea on a 4-layer pcb?

3 votes
Accepted

Receiving power from antenna (Homework)

3 votes

UART on dsPIC33EP512MU810

3 votes

How much will a switching regulator influence my RF transmission?

3 votes

How to connect battery pack with AC/DC out to marine amplifier with screw type terminal block connection?

3 votes
Accepted

Side of length matching within a differential signal

2 votes

capacitor ground or not?

2 votes
Accepted

Using a 120W inverter with a 180W brick

2 votes

How to drive a cd4051 analog mux with buttons as channel selector?

2 votes
Accepted

Use RS232 - RS422 Converter with Encoder

2 votes

Overvoltage protection circuit

2 votes

Voltage through an inductor

2 votes

Will a 300A HV connector fail before a 600A fuse does?

2 votes

How to differentiate between multiple different connections connecting to a common socket?

2 votes
Accepted

How can I use an IC family or adapter to switch automatically from solar cell to batteries & reverse?

2 votes

How can I change the circuit or the current to effectively heat up the diodes based on their current rating?

2 votes

How to I calculate max current draw for this circuit?

2 votes

Can I use an LDO to control several diodes at a speed in the order of kHz?

2 votes

Does using voltage regulator in power supply further reduces the rippling?