Skip to main content
AlmostDone's user avatar
AlmostDone's user avatar
AlmostDone's user avatar
AlmostDone
  • Member for 6 years, 3 months
  • Last seen more than 2 years ago
14 votes
Accepted

What is Namur, and how does it work?

13 votes
Accepted

LM2586 - Inductor Heats Then Burns

5 votes

How to convert a metal work table surface for electronic work?

5 votes
Accepted

Multi-tuning AM selector

4 votes

I need the name of this one "component"

4 votes

LTSpice Has bizzare results for high input impedance devices

4 votes
Accepted

Is there a better way to jumper 3 terminals together?

4 votes
Accepted

TTL, Totem Pole vs. Open Collector Output

3 votes

Why isn't the ESP32 used for quadcopter flight control?

3 votes

Suitable 12VDC Communication protocol for untwisted unshielded long-ish wire length?

3 votes

Detect voltage below 0.7V?

3 votes

What is the purpose of a resistor network?

3 votes

Delaying a TTL signal

3 votes

Replacing half wave tube rectifier with capacitor diodes in series

3 votes

HEX to 7 segment decoder for a common anode 7 SEG display

2 votes

When to use an RTOS?

2 votes
Accepted

Limiting Inrush on AC/DC converter

2 votes

Why do rubber duck antennas have this metal part, while other antennas do not?

2 votes

Can I power 100 ATMega328 in parallel?

2 votes

Decipher this capacitor's label?

2 votes
Accepted

Read multiple modbus devices information by multiple PLC

2 votes

Is it possible to make a coil-less simple Shortwave Receiver

2 votes

convert from serial modbus to ethernet through plc?

2 votes
Accepted

CE certification

2 votes

rs422/485 maximum terminator resistor value

1 vote

Safety Standards for Low Voltage Systems

1 vote

2-wire MPU interface / 2-wire Serial Control Interface?

1 vote
Accepted

Getting rid of charge injection click and hum sound on this switch I have designed

1 vote

What would happen if I plugged a power adapter into two different sockets

1 vote

Two TTL pulses mutiplexed on one wire