Skip to main content
devnull's user avatar
devnull's user avatar
devnull's user avatar
devnull
  • Member for 5 years, 10 months
  • Last seen this week
  • Milky Way
29 votes
Accepted

RISC-V Zero Instruction Question

23 votes

None-inverting op-amp must zero output, why not?

19 votes

What does the multimeter dial do internally?

19 votes

Can an oscilloscope be used as an EKG?

13 votes
Accepted

LTSpice: How to change x-axis (ac sweep)

12 votes
Accepted

Can simple DC/DC linear regulators be used in parallel?

10 votes
Accepted

What is a hardware thread in RISC-V?

10 votes

Need help understanding schematics in LT1019 datasheet

10 votes

Differential probe input impedance 1Meg, but 50ohm oscilloscope mode recommended

9 votes
Accepted

Kelvin type connection

9 votes
Accepted

Op-Amp Voltage Follower not working at "extreme" voltages

8 votes

LTSpice: Why are my capacitors half charged at simulation start?

8 votes
Accepted

Dflop not working on LTspice

8 votes
Accepted

How to choose the RC values between a buffer and an ADC input?

8 votes

Logic value of a single input pin into a microcontroller

8 votes

How do I change the output voltage of the LM7805?

8 votes

Calculate Power Dissipation of 0ohm resistor

7 votes

Capacitor as a ripple filter in the rectifier circuit - difference in charging and discharging time

7 votes

Is the RMS value the same after you pass it through a full wave bridge rectifer?

7 votes

Which reverse polarity protection is better and why?

7 votes
Accepted

Why does the Arduino give me a value of 1023?

7 votes

What is RCC in embedded C using registers? A register, or a pointer to a register, or something else?

7 votes

Half wave rectifier query

6 votes
Accepted

Output Voltage Range of Op amps

6 votes

OpAmp input impedance when working with DC signal

6 votes
Accepted

How can A/D conversion perform linearization of nonlinear I/O behavior of sensor recordings?

6 votes

LTspice working with a dual opamp

6 votes

Intuitive explanation for RMS voltage of discontinous sinewave

6 votes
Accepted

Flash ADC - Why R/2 at the ends of the resistor ladder?

5 votes

I'm new to circuit analysis and completely stumped on this circuit. Could someone please help me understand the steps to solve it?

1
2 3 4 5
9