Mattman944's user avatar
Mattman944's user avatar
Mattman944's user avatar
Mattman944
  • Member for 5 years
  • Last seen this week
31 votes

Why do radiation hardened IC packages often have long leads?

23 votes

Resistance depending on voltage - the chicken and the egg?

17 votes
Accepted

How to estimate the number of components on a tape reel?

17 votes
Accepted

Logic-level transistor not switching

17 votes

Why is the 8061 microcontroller described as having 256 bytes of internal memory?

15 votes
Accepted

How Many EEPROM Write Cycles Left in My EEPROM

15 votes

SN74LS93N is not counting as expected

15 votes

How to make electronic systems which work below −40°C (−40°F)?

15 votes
Accepted

How does this transistor (pre-)amplifier work?

15 votes

How do I measure the capacitance of a 0603 capacitor which is in the order of pF?

15 votes
Accepted

Measuring capacitance by measuring rising time

14 votes
Accepted

Decoupling capacitors where VDD/VSS pins are spaced apart

14 votes
Accepted

Can anyone help identify this mystery integrated circuit?

13 votes

How would an alarm button work in a bathroom scale?

13 votes

How to calculate the effect of different voltages on an incandescent bulb?

13 votes

How can I make a reliable tick tock sound electro-mechanically?

12 votes
Accepted

How to get an analog signal 0 to 12 V DC based on reference 0 to 5 V DC?

11 votes
Accepted

How can I wire a 9-position switch so that each position turns on one more LED than the one before?

11 votes

Decode/Analyse the following UART signals

11 votes
Accepted

How to interpret this Zener diode IV characteristic diagram?

11 votes

Working with wooden breadboard - recommended materials

11 votes
Accepted

Sizing a capacitor for MCU's Vs to withstand cold cranking amps of an engine

10 votes

Using two 2 channel oscilloscopes instead of one 4 channel oscilloscope

10 votes

Rechargable batteries vs alkaline

10 votes
Accepted

MCU with ultra low energy gpio input

9 votes
Accepted

Debugging a multilayer PCB?

9 votes

Why is the metal tab of a BJT power transistor is always connected to its collector pin?

9 votes

3.6 V Zener diodes clamping at 2.3 V

8 votes

Why is a register initialised through bitwise operations instead of a binary string?

8 votes

High current headers/ jumpers

1
2 3 4 5
18