Jules's user avatar
Jules's user avatar
Jules's user avatar
Jules
  • Member for 11 years
  • Last seen more than a month ago
39 votes
Accepted

What are the differences between shift register ICs?

8 votes

Can 50 Arduinos be daisy chained?

7 votes

What happens to components which stop being manufactured?

6 votes
Accepted

Driving blue led directly from GPIO

5 votes

What is the true circuit behind an opamp?

5 votes

16 bit Graphics Chip

4 votes

How to select step-down converter chip?

4 votes

How many cubic feet can 1 Peltier diode cool efficiently?

4 votes

Understanding ARM instruction for numerical literal

4 votes

Using a transistor as a switch between RX and TX

3 votes

SRAM Decoder Size

3 votes
Accepted

Driving 7 segment displays for a 16bit breadboard computer

3 votes
Accepted

ModelSim Altera: simulating the "lpm_add_sub" module?

3 votes

Why motherboards have two pins for LEDs, led+ and led-

2 votes

What is a modern SN74141 alternative?

2 votes

VHDL -- When is a process block too long?

2 votes
Accepted

Removing pins/wires on cables (IDE)

2 votes
Accepted

Buck, Boost..etc Is there always an IC for that?

1 vote

The number of cycles needed to execute the following loop in pipeline processor?

1 vote

I2C device lists 20mA max current on AD, CL, and DA pins. Do I need a resistor between it and Arduino?

1 vote
Accepted

Is it possible to build a CPU from content-addressable memory?

1 vote
Accepted

Connecting an arduino to desktop speakers

1 vote

Mosfet with arduino

1 vote

How much is VLIW power- and area-efficient then superscalar anyway?

1 vote

Can I output a HDMI signal with an Arduino?

1 vote

Making a counter that goes from 1 to 6

1 vote

I have output from ADC as MISO and MOSI, can I use this signals to TX and RX in arduino uno? if not what will the solution for this?

1 vote
Accepted

Schematic Critique - ATMEGA328P & VS1063

1 vote

DC solution failed using EasyEDA

1 vote

Design of a differential digital signal buffer, 250MHz, 1V output swing