Skip to main content
Marcos G.'s user avatar
Marcos G.'s user avatar
Marcos G.'s user avatar
Marcos G.
  • Member for 5 years, 2 months
  • Last seen more than a month ago
4 votes
Accepted

Why do vibration sensors use a negative voltage?

2 votes
Accepted

Modbus: Sensors timed out when plugging another sensor

2 votes

PL-2303TA TTL UART data corruption

2 votes
Accepted

AC servo ASDA-B2 modbus position control

1 vote

Electronically verify whether a cable is connected to an RJ45 connector

1 vote
Accepted

PIC CCP in compare mode not changing CCP2 pin

1 vote

How to look at the emitted assembly code of MPLAB X IDE

1 vote
Accepted

Implementing Modbus RTU on a UART device

1 vote

RS485 full duplex to Adapter with A and B ports

1 vote

What is meant by the response time of a temperature transducer?

1 vote

PIC18F26J50: how to use printf in C18

1 vote
Accepted

TTL to RS485 converter faulty outputs

1 vote

Isolated UART communication: Which side should send the supply for the isolator?

1 vote
Accepted

Writing commands to a microcontroller with a STM32f chip from python

1 vote

uncertainty estimation for a DMM voltage measurement

1 vote

Modbus acquisition timings

0 votes
Accepted

How do I connect a bno055 chip to a Linux pc via an FTDI UART breakout sensor?

0 votes

Communication between device for 5 meters and low speeds

0 votes

How VFD affects an isolated IOT system

0 votes

MODBUS RTU reading on Jetson Nano over RS485

0 votes

Measurement range versus calibration in electronic instrumentation

0 votes

Machine comms troubleshooting