Daniel K's user avatar
Daniel K's user avatar
Daniel K's user avatar
Daniel K
  • Member for 4 years, 9 months
  • Last seen more than 2 years ago
  • Austria
11 votes
Accepted

What does this value mean in a BJT datasheet?

8 votes

Does anyone have problems with micro USB connectors on PCB?

7 votes

Can I use a 3 pin kettle power lead instead of a 2 pin kettle power lead

4 votes
Accepted

Does 1200mAh Lipo battery will kill my circuit? help me to read the data sheet please!

3 votes
Accepted

To connect Active GPS Antenna wires on PCBA should Solder or use Connector

3 votes

Can I use a computer UPS with an oscilloscope?

2 votes

Desoldering mosfets on a heatsink at once

1 vote

Why does dropping my laptop's AC adapter in the floor make it work again?

1 vote

SPI pins in wifi module module

1 vote

Does the LT Spice monte carlo simulation definitely output the max and min voltage for any number of simulation runs?

1 vote
Accepted

Clearance between hole and power plane after removing unused via pads

1 vote
Accepted

step up from 2 AA to 3.3V

1 vote

How to import PCB 3D model (step file) designed in MCAD software in Altium and place PCB footprints, and route it?

1 vote
Accepted

Altium - broken unconnected nets

0 votes

Altium Designer 19.1.5: very dark 3D preview, black footprints

0 votes
Accepted

Operational amplifier output voltage calculation

0 votes

Which is a better conductor, a very thick rubber wire or a very thin copper wire?

0 votes

Mutual capacitance sensor behaviour

-1 votes

Is a type-2 system always unstable?