user avatar
user avatar
user avatar
ty_1917
  • Member for 2 years, 7 months
  • Last seen more than a month ago
7 votes
5 answers
3k views

How can I estimate the speed of this code section for this microcontroller?

6 votes
9 answers
15k views

What could be the reason that this transistor gets too hot unexpectedly?

4 votes
4 answers
426 views

Confused with the effect number of decimals at the output of transducer

3 votes
2 answers
234 views

What is the vertical scale set for this scope screen?

3 votes
1 answer
142 views

A question about type of electrical connector

3 votes
1 answer
288 views

Why there is one line of code for DAC buffer settings STM32?

3 votes
1 answer
93 views

Confusion with using non-inverting input to fix common mode voltage

2 votes
2 answers
233 views

Offset in creating delay between two PWM in STM32 board

2 votes
1 answer
80 views

Confusion with Wheatstone bridge resistor terminology in datasheets

2 votes
2 answers
568 views

What could be the purpose of the diode at emitter for this transistor buffer?

1 vote
3 answers
962 views

A basic question about opamp buffer offset and input offset voltage

1 vote
2 answers
191 views

Will the MOSFET survive with this negative gate voltage?

1 vote
2 answers
803 views

A very basic question about PLC field input switches

1 vote
3 answers
121 views

Stuck with deciding the location and the type of variable declarations for this MCU code

1 vote
2 answers
59 views

How to estimate the linearity of this servo from its datasheet

1 vote
2 answers
69 views

How to estimate the DC error for this input and opamp?

1 vote
1 answer
72 views

How to simulate this circuit for common mode voltage effect?

1 vote
2 answers
94 views

A newbie question about SPI settings for an STM32 microcontroller board

1 vote
1 answer
112 views

A question about STM32 global timers

1 vote
1 answer
244 views

Do I need to buffer these sensor outputs in this scenario?

0 votes
2 answers
139 views

How to obtain the transfer function of this sensor?

0 votes
3 answers
112 views

Different outputs of a sensor in its recommended load range

0 votes
1 answer
47 views

Confusion with analog input range spec from a manual

0 votes
2 answers
117 views

Very confused with a DAC's SPI protocol

0 votes
1 answer
53 views

Detecting threshold with an MCU at particular variation speed

0 votes
1 answer
188 views

How to set idle PWM output as LOW in timer settings in STM32 board?

0 votes
1 answer
31 views

A question about input rating of a transistor module

0 votes
2 answers
82 views

How can I safely connect 230V AC to this relay?

0 votes
3 answers
130 views

What could be the reason for this flickering of this periodic pulse train?

0 votes
1 answer
62 views

Is placing the ground in this small signal model wrong?