ScienceGeyser's user avatar
ScienceGeyser's user avatar
ScienceGeyser's user avatar
ScienceGeyser
  • Member for 1 year, 7 months
  • Last seen more than 1 year ago
8 votes

Voltage drop across opposite diodes in series

7 votes

Is it wattage that kills you and not specifically amps

6 votes
Accepted

Always-on socket in-between a 2-way switch?

6 votes

Why do single transistor oscillators work to power a transformer, if a transformer needs AC?

4 votes

using Schmitt trigger to debounce a switch

4 votes

Non polarized capacitor uses

4 votes

MOSFET Drain - Source Current limiting

4 votes

Is binary data in actuality a range of high and low to mean each in Computer Science

3 votes

How to protect Microcontroller from any damage if there is motors and sensors on PCB

3 votes
Accepted

MOSFET on condition - Relationship between drain-gate voltage and drain-source voltage?

3 votes

Can someone tell me if my doorbell wiring is low voltage?

3 votes

Current Measurement Using a Multimeter

3 votes

Digital output of the STM32L152RE: toggling between +/- V?

3 votes
Accepted

Why would you protect a 120-277 LED driver with a fuse that is 600V rated

3 votes

Can I run a VFD off a generator?

3 votes

Should I get a response when beeping two GND pins on a CPLD?

2 votes

Variability in color temperature of white LEDs

2 votes

Purpose of resistor to ground in video-amp circuit

2 votes

4-20mA sensor to a microcontroller

2 votes

How does this oscillator circuit work?

2 votes

How do I safely discharge a 3900 pF 3 kV (and 9 kV) capacitor?

2 votes

7-Segment display won't light up fully for each number in 2-Bit Counter

2 votes

What does I/O/T stand for in a pinout diagram? (ESP32-S2)

2 votes

Controlling two devices with the same push button

2 votes
Accepted

Trying to understand MOSFET Turn on Procedure

2 votes

Why are two 1 kΩ resistors used for this additive stereo to mono conversion? (For audio inputs to an amplifier)

2 votes

trying to understand erratic LEDs behavior

1 vote

How to control cell balance FET with 5V logic?

1 vote

How to properly couple an audio (headphones) signal from a big/unknown system (worried about short circuits and ground loops)

1 vote

I'm having issues setting up the LM13700 as a floating resistor and measuring the correct resistance values