Skip to main content
Prathik Prashanth's user avatar
Prathik Prashanth's user avatar
Prathik Prashanth's user avatar
Prathik Prashanth
  • Member for 3 years, 6 months
  • Last seen more than 1 year ago
7 votes
Accepted

Is the resonance frequency actually at the center of the passband of a bandpass filter?

5 votes

IGBT won't open in spark circuit

4 votes

MIC2251 5V Booster - voltage drops when load is connected

4 votes

Multi-level inverters

4 votes

Output voltage accuracy vs output ripple of a linear regulator

3 votes

Two BJTs together

3 votes
Accepted

Can I combine the + and - output of two different DC/DC converters or would that short the components?

2 votes
Accepted

DC/DC output ripple voltage

2 votes
Accepted

Possibly unstable output of linear power supply due to very large current amplfication

2 votes
Accepted

Choosing the right voltage regulation - 12/24V to 5V

2 votes

How does the inductor current ripple influence a switch-mode power supply?

2 votes
Accepted

Forcing a Buck Converter IC to behave like a Boost Converter

1 vote

Should I use separate grounds for these voltage regulators?

1 vote
Accepted

How can I carry DC component to negative side?

1 vote

Using supercapacitors on DC-DC converter output for high in-rush current

1 vote

Driving a MOSFET with a lower Vgs than required?

1 vote

Connecting analog GND and power GND

1 vote

What is the proper way to ground this DC circuit?

1 vote
Accepted

Linear voltage regulator dropout voltage

1 vote

High-side NMOS for buck converter?

1 vote
Accepted

What's the name of this DC-DC topology?

1 vote
Accepted

Current Feedback/Sense Circuit

1 vote

What rating of SMPS is perfect input to buck converter for 10A output

1 vote

Three phase rectifier with thyristors not working as expected

1 vote

Multi-phase buck converter inductor selection

0 votes

24V Bridge Rectified Relay Circuit blowing L7805 & PIC18F

0 votes

Saturation for emitter follower

0 votes

Buck converter waveform

0 votes

Switch on/off connection between variable voltage source and load

0 votes
Accepted

Trouble connecting the STM32 blue pill - Cannot open COM3 port error