stretch's user avatar
stretch's user avatar
stretch's user avatar
stretch
  • Member for 2 years, 5 months
  • Last seen this week
  • Columbia, MD, United States
8 votes

A circuit cannot contain two different currents in series; otherwise KCL will be violated

6 votes

Determine Thevenin's equivalent circuit

4 votes

How does an SR latch prevent switch bouncing?

4 votes

LM7805 reverse polarity protection

2 votes

Current Division Question

2 votes

Special case nodal analysis

1 vote

Series RLC - how does resonance amplify?

1 vote

74121 one-shot trigger on inputs A and B - can B be held low continuously?

1 vote

Are these resistors in parallel?

1 vote

How I can calculate the switching frequency of an SCR and replacing diode with SCR in boost converter?

1 vote

Understanding the odd behavior of this current loop transmitter

1 vote

Using 110 Vac incandescent light bulb at 220 Vac with a series diode

1 vote

Can I use a normal diode as a Zener/Varistor ? If not, why not? (focus on Varistor use)

0 votes

How do I find Vo in the circuit?

0 votes

Do active filters count as amplifers?

0 votes

How can I limit the DC input voltage from an AC rectified source to keep it within limits for 7805?

0 votes

Application of superposition theorem in solving the voltages of the diodes

0 votes

Circuit to reset a 4017 decade counter to 1

0 votes

Relationship between Vin and Vout of a linear voltage regulator in saturation region

0 votes

I have found the Rth=10 ohms, However i can't find the thevenin's voltage(between a &b)

0 votes

Working out Thévenin voltage with no voltage source

0 votes

Calculating resistor's current and voltage using Thevenin's theorem

0 votes

Is this a series or parallel circuit? Why?

0 votes

Trying to fix leakage issue in this under-voltage cut-off circuit

0 votes

How does current stay the same after being subtracted by an opposing current in a subloop?

0 votes

How does an inductor behave alone with a voltage source?

0 votes

I have 3 questions about current source. I'm confused if the current source gives the final current in a mesh or do I still need to add/subtract

0 votes

Apparent power vs. true power reading

0 votes

Confusion with negative voltages in this opamp circuit

0 votes

What exactly happens when you connect two voltage sources in parallel? Why isn't it the same case when they are connected in series?