Clint Lawrence's user avatar
Clint Lawrence's user avatar
Clint Lawrence's user avatar
Clint Lawrence
  • Member for 14 years, 5 months
  • Last seen more than a month ago
  • Australia
35 votes

Which electronics components should I always have on hand?

15 votes
Accepted

Good book for non-beginner firmware development

15 votes
Accepted

What are some 'gotchas' of high-frequency board design?

15 votes
Accepted

Maximum sample rate of Arduino Duemilanove?

12 votes
Accepted

Audio delay using discrete components

11 votes
Accepted

Minimum ATMega328 speed with UART

11 votes

DC boost for low voltage?

8 votes

Olimex Arm USB JTAG Programmer Problems

8 votes
Accepted

Does the TL431 have a "dropout voltage" per se?

7 votes

PIC voltage measurement

7 votes

Flyback protection for a DC latching solenoid?

7 votes

Where to cut my power supply for Arduino?

6 votes

In theory, is it possible to make a logic gate that uses zero current?

6 votes

Are decoupling caps necessary for analog ICs (e.g. LM339, LM324...)?

6 votes
Accepted

Transistor with emitter resistor calculation

6 votes

How to do circuit analysis using Matlab?

5 votes

Execute instructions from RAM in a hobbyist-friendy microcontroller

5 votes

TSOT-23-6 vs SOT-23-6

5 votes

Is a single channel oscilloscope enough for most purposes?

5 votes
Accepted

Astable multivibrator with increasing frequency

4 votes

Reading RTD Temperature Sensor

4 votes

Arduino PWM controlling high-power LED

4 votes

How are new 'best performance in the world' devices measured?

3 votes

What's causing this high frequency ripple on the output of my LM317?

3 votes

Best/cheapest way to cheaply get a 5-bit DAC: R-2R, or R = 2^N

3 votes

Reflow at home or solder manually?

3 votes

Arduino for time lapse photography

2 votes

Steam plant data logging

2 votes

Book on memory from hardware perspective?

2 votes
Accepted

How should unidentifiable breakers and fuses be represented in arc flash studies?