user avatar
user avatar
user avatar
Jason S
  • Member for 12 years, 8 months
  • Last seen more than a month ago
63 votes

Is C++ suitable for embedded systems?

42 votes

Tradeoffs when considering SPI or I2C?

29 votes
Accepted

RTOS for Embedded Systems

26 votes
Accepted

How does an LM7805 voltage regulator work?

23 votes
Accepted

Can I safely trickle charge a 24v garage actuator battery with a pair of 12v solar panels?

23 votes
Accepted

How to control a 12V solenoid valve with a mosfet?

19 votes

How to convert AC to DC

17 votes

Using diodes to limit current to LEDs

17 votes

Which electronics components should I always have on hand?

17 votes
Accepted

Differences between thermistors and thermocouples

15 votes
Accepted

Understanding motor constants Kt and Kemf for comparing brushless DC motors

15 votes

I2C 3.3 to 5.0 V conversion

14 votes

Good tools for drawing schematics

14 votes
Accepted

Sizing SMD components for Hobbyist Kits

14 votes

Considerations when using internal pull-up/down resistors

13 votes

Which electronics components should I always have on hand?

13 votes

How to choose an FPGA?

13 votes
Accepted

How are SMD microcontrollers preloaded with code?

12 votes

Switching DC with MOSFET: p-Channel or n-Channel; Low Side Load or High Side Load?

12 votes

Determine MOSFET switching speed

12 votes

What is this: a dual CAP?

11 votes

Why do utility companies supply at a frequency of either 50/60 Hz?

11 votes

Are there reasons *not* to have a copper-pour ground plane on a PCB?

11 votes

Why do you need 2 resistors when hooking up a transistor as a switch

11 votes

What's a good square wave generator?

11 votes

How to identify LED markers by modulating their brightness?

11 votes
Accepted

BLDC and three phase inverter

10 votes

SPI or I2C: which to use for a longish bus

10 votes
Accepted

Best PIC programmer?

10 votes

DC boost for low voltage?

1
2 3 4 5
8