Skip to main content
kruemi's user avatar
kruemi's user avatar
kruemi's user avatar
kruemi
  • Member for 10 years, 5 months
  • Last seen this week
  • Switzerland
20 votes
Accepted

Should SMD footprints be rounded?

18 votes

Can extra long pads cause problems?

12 votes
Accepted

How can the RMW instructions on PIC14 take a single cycle?

11 votes
Accepted

Why do NPNP thyristors remain on but NPN transistors don't after gate voltage is removed?

9 votes

Must RS-232 devices use the same logic level?

7 votes

Why does this battery use 4.2 V when its nominal voltage is 3.7 V?

7 votes

Does changing the gap between plates change the capacitor voltage?

6 votes

How should I wire the flyback diode on this relay?

6 votes
Accepted

2K EEPROM has only 1K?

6 votes

How can I increase the full scale of an analog voltmeter and analog current meter or ammeter?

6 votes

How to check if a capacitor is soldered ok

5 votes

Why don't we use MOSFETs in the Darlington configuration?

5 votes

Segger J-tag vs J-link

5 votes
Accepted

Self-contradictory combinations, are my explanations correct?

5 votes
Accepted

How can failure of Class Y capacitors lead to electric shock?

4 votes

LED reverse voltage

4 votes
Accepted

Transformer is not essential in half wave rectifier

4 votes

Why does the output voltage of this rectifier only reach 45V?

4 votes

Which capacitors to use with voltage regulator IC such as 7805?

4 votes

Long term issues with AC/DC converter in always ON application

4 votes

Is it possible to make an MCU hang by messing with its power?

4 votes

Is it possible to protect a circuit from reverse voltage by adding a diode between two poles?

4 votes

How will be the energy consumption curve of a Li-Ion / Li-Polymer charger?

3 votes

Which layer should I use for high power signals in a four layers PCB?

3 votes
Accepted

Can SMD 22uH (shielded) inductor cause health hazards?

3 votes

5V on DP and DM pins on FT232RL?

3 votes

Solid polymer electrolytic capacitor storage reliability

3 votes

How would you Improve the Smoothness of a 12V DC Motor Drive with Limited PWM Frequency?

3 votes

why did my powered usb hub kill my computer's usb port?

3 votes

Generating a 1pps signal with ~0.1ppm accuracy