user avatar
user avatar
user avatar
Sclrx
  • Member for 8 years, 5 months
  • Last seen more than 1 year ago
  • Belgium
20 votes
Accepted

What is the purpose of copper planes in a switching power supply?

17 votes

Can I use I2C over 2m cables?

9 votes

Can a PWM with 1% resolution in a PID heater loop achieve better than 1% temperature accuracy?

6 votes

Excess energy from my off grid system

6 votes

Is there a way to self hardreset /restart microcontroller?

6 votes
Accepted

When to use the word inductance and when to use inductivity?

5 votes

Are there any standard patterns for wiring a breadboard/solderboard?

4 votes
Accepted

Problem with breadboard wires overheating and melting

4 votes
Accepted

PWM to analog 1-10V converter: help to understand how it works

4 votes

What should be assumed regarding the upper frequency of sma connectors

4 votes

How to choose or design a suitable single board computer (SBC)?

3 votes
Accepted

Guidance on use of vias on power pins of ICs

3 votes
Accepted

Can anyone explain the point of this dual PNP/NPN set?

3 votes

How can I measure latency in a CAN bus?

3 votes
Accepted

What is the use of series resistor in VBAT line of CAN transceiver?

3 votes
Accepted

Voltage spike in pump/fan combination killing fan

3 votes

Is the maximum current of a wire related with its length?

3 votes
Accepted

Unexpected voltage drop

3 votes
Accepted

How to safely use RPi GPIO to detect if computer is on

2 votes
Accepted

PID for thermal protection

2 votes

High voltage dielectric breakdown & layering insulators

2 votes
Accepted

Is it ok to replace a tantalium decoupling capacitor with ceramic?

1 vote

Why might a thick wire be bad?

1 vote
Accepted

Do I need to connect both GND and both VCC on this addressible LED?

1 vote

how to find impedance of inductance with square wave input

1 vote

Question about proper PCB stack-up

1 vote
Accepted

Is there a low voltage LED alternative?

1 vote

Heat dissipation by convection for ICs placed upside down

1 vote

Solder Paste vs Solder Flux

1 vote

Solar panel + battery + DC load