Dejvid_no1's user avatar
Dejvid_no1's user avatar
Dejvid_no1's user avatar
Dejvid_no1
  • Member for 9 years, 8 months
  • Last seen this week
14 votes
Accepted

If Li-Ion battery is deeply discharged, is it harmful for it to remain in this state unused?

10 votes
Accepted

Lead acid battery boiling during charging: this is bad, right?

9 votes
Accepted

Why would a switching power supply fail with a battery supply?

9 votes
Accepted

Max voltage for Arduino ATmega328 VCC pin (not raw!)

8 votes

Circuit breaker vs. electric heaters

7 votes
Accepted

Step-down Regulator Voltage Drop / Frying

6 votes
Accepted

Can OP27 Trim pins float?

5 votes
Accepted

What does the circle with the “X” and the cross mean?

5 votes

Standard nomenclature for 2-row connector numbering schemes

4 votes
Accepted

LiPo charger MCP73831 does not light an LED with it's STAT pin when done charging

4 votes
Accepted

Why does a BJT act as an amplifier in the linear region?

4 votes
Accepted

Accelerometer sensitivity range

4 votes

In a car, what is the difference between a 12-V and a 24-V system?

4 votes
Accepted

I2C level translation mosfets obtainable to hobbyists

3 votes
Accepted

How to get 200mA/6v supply for MG-811 sensor from 2A/5vdc psu in small form factor?

3 votes

Microcontroller is being powered by the UART connection

3 votes

Do I need a pull-up / pull-down resistor to sense 12 V on the 12V_IGN rail in an automobile?

3 votes

Testing a sensor if it's working

3 votes
Accepted

TP4056 power sharing circuit Rpull

3 votes

what does mean Khz in voltage regulator

3 votes

Using 15 V laptop charger to power 14.4 V speakers

3 votes
Accepted

Optimizing product tests?

3 votes
Accepted

Significance of gl/gG rating on circuit breaker

3 votes
Accepted

What connector for this cable?

3 votes
Accepted

HP/Agilent Power Supply Age

3 votes

Altium: Correct pin electrical type for Vin and Vout pins on schematic symbol

2 votes

How do you deal with worn wires?

2 votes

LTspice automation

2 votes
Accepted

Electrical Connectors - To Split Pin or Not To Split Pin, That is The Question

2 votes

Attaching a heatsink to a DRV8825 stepper motor driver

1
2 3 4 5