user avatar
user avatar
user avatar
mcmiln
  • Member for 8 years
  • Last seen more than 3 years ago
  • Seattle, WA
7 votes

Mixed Signal PCB, 2 or 4 Layer?

7 votes
Accepted

How bad is it to places vias under a QFN thermal pad?

3 votes

How to test if my circuit is affected by noise?

3 votes
Accepted

Question on 3DS power adapters, minor voltage difference

2 votes

Estimation of swimmer's velocity from IMU sensor

2 votes
Accepted

Estimating processing power required

2 votes

What are the terminals in this 6 pin potentiometer?

2 votes
Accepted

FPGA Simulation - does it need FPGA hardware?

2 votes

Why there is no decoupling capacitors in analog IC

1 vote

How to design Digital logic gate using TFET logic?

1 vote

Is it necessary to separate ground planes in a PCB if there are different voltages?

1 vote

Changing the data logging rate on a Tektronix DSO

1 vote

Automate Noise Sensitive Designs of SMD For 95% Sensitivity

1 vote

Program to make bode plot of transfer function?

1 vote

Broadcom component library for Eagle circuit design software?

1 vote

How instruction skipping is avoided during procedure calls in pipelined architectures?

1 vote
Accepted

Input/output for buck-boost converter controller implemented with FPGA

1 vote

Voltage Supervisor for low battery

1 vote

Programmed IO vs interrupt for devices

1 vote

What module to look for if I want to tell if there's Wi-Fi in the air?

1 vote

MOSFET saturation case?

1 vote

JTAG connector - large pitch to smaller one

1 vote

FPGA Frequency divider with linear regulation

1 vote
Accepted

Bluetooth Modules in a plastic enclosure

1 vote

How can I fix a "singing" capacitor

1 vote

Understanding how to use an accelerometer to detect vehicle collisions

1 vote
Accepted

How to create a bluetooth module that is both a master and slave?

0 votes

Can I convert my 3.7 volt lithium ion batteries into a usb charging power bank?

0 votes

How to calculate the reset time?

0 votes

How to make T-flip-flop into an 8 bit counter?