Skip to main content
KarlKarlsom's user avatar
KarlKarlsom's user avatar
KarlKarlsom's user avatar
KarlKarlsom
  • Member for 9 years, 6 months
  • Last seen this week
23 votes

What will happen if the output from a NOT-gate injected- BACK to its OWN input?

5 votes
Accepted

Why stepping up voltage during transmission considers \$I^2 R\$ but not \$\frac{V^2}{R}\$?

4 votes

Building an appliance with two plugs to get double the voltage?

3 votes
Accepted

I fried my multimeter while connecting it to AC

3 votes
Accepted

What are all the reasons that transformers are considered safer?

3 votes
Accepted

Step up 3.3V to 5V and draw 500mA without a voltage collapse/break down

3 votes

P-channel MOSFET inrush current limiting

2 votes

Dual rail reverse voltage protection

2 votes

Trace width and clearance calculations

2 votes

Why my boost converter is not boosting the voltage?

2 votes

Does several PIC12F683 pull-ups cause short circuit

2 votes

An SPDT switch using TRIACs

2 votes
Accepted

Weird value of track width with calculator

1 vote
Accepted

OpAmp circuit with diodes: conduction conditions

1 vote

How to remove DC offset of the input signal without using an opAmp?

1 vote
Accepted

High side switching

1 vote
Accepted

RC circuit How does the current vary after the switch is closed?

1 vote

Timer Interrupt not working as expected on ATMEGA808/1608

1 vote
Accepted

MCP2515 CAN Transceivers can't go higher than 125kbps

1 vote

How to edit the shape of pads for a component footprint in Fusion 360?

1 vote
Accepted

Is it possible to mount a 7-Segment on an FPC and what points need to be considered?

1 vote

Discharging 100 A battery

0 votes

Atmel Xmega ADC input voltage range - Can the ADC be damaged by exceeding it's reference voltage, if the input is still less then VCC?

0 votes

How does the ELPF and XTAL inputs on the ADV7180 recommended circuit work?

0 votes

ATSAMC21 - CAN configuration - Nominal bit timing vs. data bit timing & time quanta calculation

0 votes
Accepted

MCP4011 - Exposed pad - connect to GND?

0 votes
Accepted

Eagle 9.5.x - custom flip-able layers

0 votes
Accepted

ATSAM / ASF4 - how to use HRI driver

0 votes

What's the differences of these usage of PNP, NPN transistors?