Bryan Boettcher's user avatar
Bryan Boettcher's user avatar
Bryan Boettcher's user avatar
Bryan Boettcher
  • Member for 12 years, 3 months
  • Last seen more than a month ago
  • Kansas City, KS
8 votes

What is the simplest sound generating circuit?

8 votes

How to detect if a nearby parked car has started engine?

7 votes
Accepted

Do I need a current limiting resistor when powering an LED below its forward voltage?

7 votes

Running my atmega8 at 5.5V, risky?

5 votes

Why does micro USB 2.0 have 5 pins, when the A-type only has 4?

5 votes
Accepted

If voltage is the same across each resistor in a parallel circuit, what's the point of resistors if there's 4 of them in a ciruit with 50volts

4 votes

TRIAC dimmer, circuit design help (resistive load)

4 votes

What would happen if I connect two different DC voltage sources in parallel?

4 votes

Soldering a wire to a small MOSFET pin

3 votes

Can an optical mouse be used to measure distance down to 1-10μm?

3 votes

Low Voltage DC controlling 120 AC, with Arduino

2 votes

How do I use a button to wake up an atmega32?

2 votes

How to design drone power tether system? (high power with ultra light cable)

2 votes

Spot welder: High current advantage over high voltage

2 votes

What type of voltage control should I use for a battery power bank (using old alk. AA, C, D...) to provide low voltage for a light?

2 votes

Can Lithium-Iron-Phosphate or LiFePO4 batteries be stored in cold?

2 votes

acceptable bounds for replacement DC adapter

2 votes

Overload protection for battery

2 votes

Where can I get a small cheap linear actuator?

2 votes

Driving a high power (200mA) LED with a GPIO and NPN transistor

1 vote

Can I reduce rpm further of a gear motor by using PWM?

1 vote

MOSFET heat calculation question

1 vote

Peltier Unit Not Working

1 vote
Accepted

How to make 5v DC UPS Circuit?

1 vote
Accepted

Iphone Lightning Charger - How would one go about it?

1 vote

Balance cable for LiPo batteries

1 vote

Li-Ion vs Li-Poly For Quads

1 vote
Accepted

Shim to make PCB section thicker

1 vote

Spark Gaps on a Tesla Coil

0 votes

Safe and stable discharge rate for Li-Ion battery packs