Skip to main content
sweber's user avatar
sweber's user avatar
sweber's user avatar
sweber
  • Member for 9 years, 8 months
  • Last seen more than a week ago
  • Germany
40 votes

Why did my fuse blow after 3+ years of no problems?

32 votes
Accepted

What and Why's of termination?

31 votes

How is it possible to have high voltage and low current? It seems to contradict the relationship between current and voltage in E=IR

16 votes
Accepted

Can current flow both ways through a transistor?

15 votes

Measuring output of solar panels for science fair project

13 votes
Accepted

'Unrouting' a ground plane on Eagle

12 votes

car A/C using peltier devices, is it feasable'

12 votes

Why was a capacitor called a condensor (condenser?) in the early days of electronics?

11 votes

What does "Piggy" mean in this Schematic?

11 votes

Schuko plug wiring

10 votes
Accepted

What does SWITCH pin do on a microSD connector?

10 votes
Accepted

Having two different ground planes on the same layer Eagle

10 votes

Non-graphical PCB design software

10 votes

If Infrared not visible, why the red LEDs?

9 votes

What is wrong with this soldering iron?

9 votes
Accepted

PCB trace electron flow

9 votes
Accepted

Why we use #pragma configs in PIC controllers?

9 votes
Accepted

Is it possible to "trace" a hall effect sensor on a PCB?

9 votes

Are two (or N) resistors in series more precise than one big resistor?

8 votes
Accepted

Eagle 'optional' solder pads

8 votes
Accepted

DIY PCB Manufacture: Photoresist or Toner Transfer?

8 votes
Accepted

Help with understanding op amp circuit using diodes at the output

8 votes

How are DACs integrated in color LCD screens?

8 votes

How do I make sure my electronics design is good from manufacturing perspective?

8 votes
Accepted

Pebbles in potted electronics

8 votes
Accepted

getting rid of little air wires in Eagle

8 votes
Accepted

Teardrops in Eagle

8 votes

How to calculate the weight my DC motor can move?

7 votes

Four layer board manufacturing question

7 votes
Accepted

Can I Reverse/upside-down mount SMD LED

1
2 3 4 5
7