Skip to main content
Samee87's user avatar
Samee87's user avatar
Samee87's user avatar
Samee87
  • Member for 9 years, 3 months
  • Last seen more than 7 years ago
  • Poughkeepsie, NY
13 votes
3 answers
39k views

How long until my eMMC is dead?

9 votes
5 answers
2k views

What's the purpose of an array of same VALUE capacitors? [duplicate]

5 votes
1 answer
513 views

Why is it that the bandwidth of a patch antenna decreases with it's size?

4 votes
2 answers
626 views

What's the point of this thick trace in my PCB?

3 votes
3 answers
2k views

What makes this active antenna "active?"

3 votes
3 answers
3k views

How does this slow turn-on regulator work?

2 votes
2 answers
381 views

What's the purpose of having two of the same value caps in parallel?

2 votes
2 answers
793 views

With regard to GPS signals, what is the significance of I-parts and Q-parts of Complex signal?

2 votes
2 answers
538 views

How can I objectively compare TCXO performance?

2 votes
1 answer
681 views

Connector datasheet is in chinese. Which part is which?

2 votes
3 answers
157 views

Whats a good naming convention for part series and shunt components?

2 votes
1 answer
172 views

What is the best way to rectify 1MHz, 50V 0.1% duty cycle signal?

2 votes
2 answers
419 views

How does RF Coax cable impedance + Microstrip impedance mismatch affect power transfer

1 vote
1 answer
325 views

What's the purpose of this capacitor?

1 vote
2 answers
488 views

Any idea on what this component is?

1 vote
1 answer
74 views

I'm comparing a couple of GNSS front-end modules. Is a lower In-band IIP3 point better or worse than a higher one?

1 vote
1 answer
312 views

If I charge a electrolytic capacitor outside of a circuit and let it sit

1 vote
1 answer
188 views

How does a device's physical size affect its parasitic capacitance?

1 vote
1 answer
743 views

Switch-mode power supply and EMI on input power line filtering

1 vote
1 answer
2k views

What does 4*1 Panel-up mean?

1 vote
2 answers
261 views

What makes an arbitrary waveform generator arbitrary?

0 votes
1 answer
58 views

Why should I bother with Frequency Response calculations in a Spilt-rail buck regulator design?

0 votes
2 answers
313 views

Do I really need an H-Bridge controller in this application?

0 votes
2 answers
3k views

What's the best way to implement a MFB low-pass filter?

0 votes
2 answers
348 views

Right half plane zero calculation

0 votes
2 answers
199 views

Do I need a dummy load for a GPS satellite signal generator?

-2 votes
1 answer
121 views

Can I reprogram my SPI flash wirelessly?