user avatar
user avatar
user avatar
Ronan Paixão
  • Member for 7 years, 3 months
  • Last seen this week
9 votes

Is there a low-cost alternative to RJ45 cables for large number of signals?

9 votes
Accepted

Under what circumstances can an FPGA or microcontroller PCB be designed to only have two layers?

9 votes

Can ESP32 be used in a commercial application?

4 votes

How does this glass-protected surge absorber work?

4 votes

How to Transition from "Basic" Microcontrollers to ARM Cortex?

3 votes

Are the instructions fetched from RAM or ROM in an ARM micro-controller?

3 votes

SPI bus connections - to loop or not to loop?

3 votes

Why would someone tend to use a high-side device instead of low-side device?

2 votes
Accepted

Can I use multiple RF433 modules at the same time?

2 votes

What are the disadvantages of using a Zener diode over a linear voltage regulator?

2 votes

How to digitize an AC signal?

2 votes

How can I be sure that a multi-bit-per-symbol encoding schema exists?

2 votes

Is it better to keep LiOn battery charge on the lows or the highs for battery lifespan?

2 votes

What is an integrated circuit equivalent for this circuit?

1 vote

Why do cables have multiple grounds?

1 vote
Accepted

Using low-voltage, charged capacitor(s) to power integrated components

1 vote

How to _disable_ USB on STM32F1xx?

1 vote

Writing embedded software w/o hardware

1 vote

Oscilloscope to monitor AVR

1 vote

Why can't you just average ADC samples to get more resolution from an ADC?

1 vote

DC motor speed control when having relay change directions

1 vote

7 segment binary to hex

1 vote

What is right or left alignment of data in ADC?

1 vote

Should the pointer datatype be always same as the data type of variable it points in embedded C?

1 vote
Accepted

How can I see if my oscillator works without using an oscilloscope?

1 vote

Why don't LEDs have built-in resistors?

1 vote

Estimating current draw for a single instruction

0 votes

Ethernet mechanical switch for testing

0 votes

Best way to power a microcontroller, SMPS vs Linear Regulator

0 votes

How to properly clean up a noisy signal with a capacitor