user avatar
user avatar
user avatar
Peter Smith
  • Member for 6 years, 11 months
  • Last seen this week
30 votes

Difference between bit rate and baud rate and its origins?

29 votes
Accepted

Analog & Power Ground Planes Doubts

25 votes
Accepted

How reliable is it to use another manufacturer's datasheet of the same part?

25 votes

What really causes series inductance of capacitors?

24 votes
Accepted

PCIe, diagnosing and improving an eye diagram

24 votes

How does a 24 volt aircraft battery power a 28 volt bus?

23 votes
Accepted

At what UART baud rate is hardware flow control required?

22 votes

Do manufacturers lie about the specifications of their components?

21 votes
Accepted

Which is better - components on both sides or components on one side of the PCB?

19 votes

what is triplication on fpga?

19 votes

Why are electrically insulating heatsinks so rare? Is it just cost?

19 votes
Accepted

Why datecode is SO IMPORTANT to chip manufacturers?

18 votes

Why is the temperature range of industrial and military products so high?

18 votes

Where Does VDD+0.3V Input Limit Come From on IC chips?

17 votes
Accepted

74HC595 - Initial output voltage

15 votes

Will a cut or a slot in a PCB change clearance or creepage?

15 votes

How are circuits which use complex ICs normally simulated?

15 votes
Accepted

In which scenarios is it important to measure microampere?

14 votes
Accepted

How does this current limiting circuit work?

14 votes

Does PCIe hotplug actually work in practice?

12 votes
Accepted

In what cases may component "Tempering" be required prior to assembly?

12 votes
Accepted

ESD protection for OpAmp inputs and outputs

12 votes

Taking a device to market

12 votes

How do you structure large embedded projects?

12 votes
Accepted

Why is it called Wired-OR when it is functioning as Wired-NOR?

11 votes

Can a decoupling capacitor be too large?

11 votes

Why do electrons move faster than holes in a semiconductor?

11 votes
Accepted

What is the use of NOT CONNECTED pin in 741 opamp?

10 votes
Accepted

Which IPC standard we should follow?

10 votes

What is the purpose of this circuit?

1
2 3 4 5
20