Skip to main content
Electrical Engineering
ElectronS's user avatar
ElectronS's user avatar
ElectronS's user avatar
ElectronS
  • Member for 9 years, 2 months
  • Last seen more than a month ago
Profile Activity

50 Answers

Score Activity Newest
18 votes
Accepted

Soldering a high-power cable to a PCB

17 votes

STM32F4 and HAL

8 votes

Making Sense of Current Sensing

8 votes

Is hot glue a good insulator?

7 votes

STM32 USB host will not return from reset request

6 votes

How many MOSFETs can we safely parallel for very high currents? I had problems with a motor application at 48 V, 1600 A

4 votes
Accepted

RS485 network ground pin - when to connect?

3 votes
Accepted

Advantage of using SMD components

3 votes

Adding Low Pass Filter to Open Collector Hall Sensor

3 votes

STM32 USB host will not return from reset request

3 votes
Accepted

MOSFET half bridge driver not working

3 votes
Accepted

FOC Motor Control Algorithm - ADC sampling

2 votes

How to connect the power plane Microchip AN2587

2 votes

dc motors to control unmanned ground vehicle

2 votes
Accepted

Somethings about Infineon BTN8962

2 votes

Industrializing a PIC micro-controller

2 votes
Accepted

Controlling 64 stepper motors with arduino

2 votes
Accepted

Serial Communication Rx ISR logic design

2 votes
Accepted

Servo control signal as analog input

2 votes
Accepted

Charging phone battery from DC supply

2 votes

Cable rating - What is the max amp for a 1.5-1.75mm cable?

1 vote
Accepted

MOSFET push pull gate driver: Too high base voltage?

1 vote

STM32F411RE UART IRQ

1 vote
Accepted

What can be microcontroller resets causes?

1 vote

Sketch current flow of circuit

1 vote
Accepted

Can you drive a motor bidirectionaly with just N channel mosfets?

1 vote

What is the purpose of the 10K resistor that is connected across the input and the supply?

1 vote

Implementation of D (differentiation) in PID

1 vote

Low side and High side switches

1 vote

Is there any motor which moves slowly and gives strong torque?

1
2