Skip to main content
DamienWontContributeToAITheft's user avatar
DamienWontContributeToAITheft's user avatar
DamienWontContributeToAITheft's user avatar
DamienWontContributeToAITheft
  • Member for 8 years, 11 months
  • Last seen more than a week ago
25 votes
Accepted

Why such "Sloppy" heating element control in a hot-tub

22 votes

RGB spectrum of an RGB LED

17 votes

Why would a current measurement shunt design use 4 sense pins?

13 votes
Accepted

Sequential EEPROM writing

9 votes
Accepted

Convert the type of calculation result in if() to uint8_t

7 votes
Accepted

What are these white/grey stains on the back of a motherboard?

6 votes

What kind of IC is this, and how can I erase its memory to reuse it?

6 votes
Accepted

Looking for the solution for very close board interconnect using pin headers

5 votes

STM32 writing to SD card using FATFS sometimes takes longer than normally

4 votes

Why should I use printf for function works fine

4 votes
Accepted

How to connect BME280 to ATmega328?

4 votes

How to convert the ADC/PDB part code of Teensy 3.2 for Teensy 4.0

4 votes

Transform 8~13V to 12V

4 votes
Accepted

AD5693 digital to analog converter

4 votes
Accepted

How to configure / construct a CMOS sensor to act on changing signals only?

4 votes

Why are my voltage regulators going into thermal shutdown, seemingly unnecessarily?

3 votes

Why do you need resistors for components, like ADS1115?

3 votes
Accepted

Making the Raspberry Pi Pico a part of my PCB

3 votes

SDA and SCL for I2C are always low

3 votes
Accepted

How can the efficiency of LED emitters be approximated?

3 votes
Accepted

Is this LCD monitor matrix damage or is something else wrong?

3 votes

Resistor switching methods

3 votes

The Differential I2C Bus Extender is only working for 1 channel

3 votes
Accepted

How is a neuromorphic chip different from an FPGA?

3 votes
Accepted

Kelvin connections in PCB

3 votes
Accepted

I2C Slave pulling SCL LOW and not returning data

3 votes

Are these LED circuits equivalent? (Samsung Standard Horticulture Gen2 Module)

2 votes

BME280 temperature sensor gives wrong readings when RGB leds are on/off

2 votes

Actively stabilizing voltage through a Raspberry Pi CM4

2 votes

Procedure to express radiantion intensity of a LED in watts/cm^2 , given luminous intensity or total radiant power