Jon Watte's user avatar
Jon Watte's user avatar
Jon Watte's user avatar
Jon Watte
  • Member for 12 years
  • Last seen this week
30 votes
Accepted

Is there a way to stop servos from "shaking"?

14 votes

Why were coax cables used for networking?

9 votes
Accepted

Charging and Using a Li-ion battery simultaneously

8 votes

Short String overflows.text area on ATtiny85, Arduino IDE

8 votes
Accepted

How to choose the right transistor for a circuit and its associated resistor?

7 votes

MOSFET as a switch?

7 votes

Why do Arduinos ship w/ 16MHz crystal instead of 20MHz?

6 votes

If i change the transformer on my inverter for a bigger one, will it increase the watts?

6 votes

Is my zener diode labeled wrong, or am i seeing a strange failure mode?

5 votes

How to read 115200 Baud digital signal on Arduino UNO?

5 votes

Is this a good design for MOSFET H-Bridge?

5 votes
Accepted

How would I delay a power on and power off

5 votes

Permission Denied on Arduino serial stream

5 votes

Limiting current for a DC motor

5 votes
Accepted

Which transistor should I use to PWM switch my car's 12V power with my Arduino's 5V?

4 votes
Accepted

Does FPGA have internal clock source?

4 votes

Reducing the clamping voltage of a TVS diode

4 votes

Multiplex dip switch input to microcontroller

4 votes

How to use measured step response to tune control system

4 votes

Best One-Off DIY PCB Creation Technique

4 votes

2 Layer Through Hole PCB

3 votes

How to program the nRF24LU1+?

3 votes

What to look for in the datasheet when choosing a MOSFET?

3 votes

PC shares memory with external microcontroller

3 votes

Why does my AVRISP MKII Programmer not work?

3 votes

How do I improve efficiency of a boost converter?

3 votes

Switch transistor with a low voltage and current

3 votes
Accepted

How does this circuit diagram work?

3 votes
Accepted

Reprogramming a Microcontroller

3 votes

LDO regulator (LD39300) output capacitor ESR not so small

1
2 3 4 5
8