Jon Watte's user avatar
Jon Watte's user avatar
Jon Watte's user avatar
Jon Watte
  • Member for 12 years, 1 month
  • Last seen more than a month ago
15 votes
1 answer
3k views

Is there a good replacement for stripboard in the surface mount world?

9 votes
2 answers
5k views

Buck switching regulator based on ATtiny84a -- please critique!

6 votes
2 answers
4k views

Proper GND pours for two-layer PCBs?

5 votes
2 answers
1k views

Does this use of IR2183 as high-side n-channel gate driver work?

5 votes
1 answer
4k views

MOSFET switch with two on/off momentary buttons -- asking for critique

4 votes
2 answers
2k views

How to lay out a schematic for review? Please critique

4 votes
1 answer
7k views

Default-on, latch-off, MOSFET power switch

4 votes
1 answer
2k views

Switching Boost Converter only works while probing with o'scope?

4 votes
1 answer
266 views

How to protect high-bandwidth low-voltage lines from transients?

4 votes
1 answer
5k views

VHDL: when is process sensitivity list triggered?

4 votes
3 answers
2k views

What's a good plastic for self-cutting solder paste stencils on a laser?

3 votes
1 answer
3k views

How to drive a high-side N-channel MOSFET with low VGS?

3 votes
4 answers
649 views

How do dual RC filters interact?

2 votes
2 answers
122 views

What's a single-ended single duplex buffer with 5V drive strength?

2 votes
1 answer
4k views

VHDL: Signal assignment question

2 votes
1 answer
215 views

Non-inverting version of EL7232? (High-frequencey 3-state DIP driver/buffer)

2 votes
1 answer
5k views

What's the use of the bypass capacitor on the LM380 amplifier?

2 votes
4 answers
2k views

How to shift differential signal to read with single ended adc?

2 votes
1 answer
709 views

Keeping a TVS diode biased continuously?

1 vote
1 answer
808 views

Is this switching power controller compromise wise?

1 vote
3 answers
725 views

Looking for a level translator for single duplex serial bus

1 vote
1 answer
377 views

How do I source an Audibly noiseless (< 3dBA) power supply?

1 vote
0 answers
185 views

How to bias an AC input composite video signal [duplicate]

1 vote
1 answer
84 views

Detecting "quick falls" in signal

1 vote
2 answers
325 views

Series resistance for DC brushed motor with PWM drive

0 votes
0 answers
48 views

How to buffer balanced (XLR) audio signal while forwarding phantom power [duplicate]

0 votes
2 answers
1k views

XLR phantom power microphone mute, redux

0 votes
1 answer
888 views

Feedback sought on audio output circuit for Teensy 3.2

0 votes
1 answer
134 views

What is the ALS and BLS pin for on the ISL83204A full-bridge driver chip?

0 votes
2 answers
2k views

How to extend the input range of a linear voltage regulator?