user avatar
user avatar
user avatar
Jim
  • Member for 6 years, 9 months
  • Last seen more than a month ago
  • Brooklyn, NY, United States
12 votes
Accepted

Pull up resistor on P-MOSFET gate. Not working

8 votes
Accepted

1117 Regulator input voltage

8 votes

How to connect a bulb and buzzer to be operated by one switch?

5 votes
Accepted

LED light intensity drop using 200k range resistors.

3 votes

Why do 2-1 muxes forming 4-1 mux have common selector?

3 votes

RJ45 connector on breadboard

3 votes

In the given circuit, will the resistor have current across it?

3 votes

Compliance Testing Strategies

3 votes
Accepted

How to turn on LED with PMOD on FPGA

2 votes

Drive P channel MOSFET with Arduino, unable to get desired behaviour (LOW pin, MOSFET ON)

2 votes

UL/IEC-60950 Standard Question

2 votes

Connect push button switch to two circuits

2 votes
Accepted

Parallel circuit not working as expected

2 votes

Which option of bonding multiple strands from Cat5 pick up the lowest level of EMI?

2 votes

Should the Unused Contact of a DPDT Relay be Connected in Parallel or Series?

2 votes
Accepted

3 AA batteries vs. USB battery pack?

2 votes
Accepted

Is there a good solution to connect Segger J-Link to a solderless breadboard?

2 votes
Accepted

In a parallel circuit where a power wire goes all the way across, why is there still current going into the circuit?

2 votes

Does connecting between two series diodes suppress noise?

2 votes
Accepted

Convert 3.3V PWM of Beaglbone black to 5V PWM

2 votes
Accepted

Are these two circuits equal and what does the arrow symbolize?

2 votes

Do I need an UL approval if I build a machine and use it in my own company?

2 votes

What type of connector is this

1 vote
Accepted

Car interior light with multiple "triggers" - 12V DC power

1 vote
Accepted

Is there a general method for switching between PCB power sources?

1 vote

If I incorporate a UL/NRTL listed power supply in our product, must we re-test?

1 vote

Best materials to prevent reverse engineering of PCBA components?

1 vote

8x1 header in OrCAD

1 vote

Why doesn't this RC circuit simulate as expected? (i.e. what am I doing wrong?)

1 vote

Powering Multiple loads from a single 12v battery