jp314's user avatar
jp314's user avatar
jp314's user avatar
jp314
  • Member for 6 years, 11 months
  • Last seen this week
30 votes
Accepted

Why do we need nonlinear electronics for computing?

25 votes

Why is the MCU clock out waveform sinusoidal and not square pulse

19 votes

Does each IC need its own bypass capacitor when there are multiple ICs in the same circuit?

18 votes

Will putting a resistor between a PC's fanheader pins convince the BIOS the fan is on?

18 votes

Why are crystal oscillators used in clocks instead of RLC circuits?

17 votes

Do stateful 74LS series chips start in a defined state?

16 votes

Are antennas specified for a certain frequency?

16 votes

Is paralleling MOSFETs a good or a bad idea?

14 votes
Accepted

How are emitter and collector different if NPN transistors are shown as being symmetrical

14 votes
Accepted

In a MOSFET, what does the P+ region mean in this picture?

13 votes

Why is silicon necessary in making semiconductors?

13 votes
Accepted

NPN transistor resistor from base to GND. Is this useful?

12 votes

What does negative capacitance mean?

12 votes

Three-phase transformer vs. three single-phase transformers

11 votes

Do I need to add buffers when creating a 3-input NAND gate from 2-input NANDS because of propagation delays?

11 votes

For a lower voltage drop one could use Schottky diodes, but what are the disadvantages of Schottky's?

10 votes
Accepted

Why does lower frequency require a lower voltage to drive a logic value?

9 votes

Why does this NPN transistor operate differently if it comes before the switched element?

9 votes
Accepted

Measure inductance of air core inductor

9 votes
Accepted

Why this pair of IGBT's died silently?

8 votes
Accepted

BJT astable multivibrator frequency increasing with voltage

8 votes

How can we be sure that computers will never accidentally switch a 0 by a 1?

8 votes

For this Art of Electronics circuit, why aren't the transistors specified? And what transistors do I use?

8 votes
Accepted

Are there two sorts of *geometry* of JFET?

7 votes

Do I need a pull-up / pull-down resistor to sense 12 V on the 12V_IGN rail in an automobile?

7 votes

Can ULN2003 be a poor-man’s matched diode array?

7 votes

Any difference in parallel and row resistor circuit?

7 votes

Is discontinuous conduction mode of a buck converter more efficient than continuous conduction mode?

7 votes
Accepted

Does an op-amp's input-referred noise increase or decrease with decreasing supply voltage?

7 votes
Accepted

Why more, smaller transistors increase power efficiency?

1
2 3 4 5
25