efox29's user avatar
efox29's user avatar
efox29's user avatar
efox29
  • Member for 12 years
  • Last seen more than a week ago
  • Mississauga, Ontario
53 votes
Accepted

Is it really OK to supply more current than what the component is rated for?

36 votes

Explain in layman's terms Vgs and Vgs(th) of MOSFET's

27 votes

How does a diode clamping circuit protect against overvoltage and ESD?

20 votes
Accepted

Why are low-dropout (LDO) voltage regulators unstable?

19 votes

Why do capacitors lose capacitance in series?

13 votes

Why do I suck at electronics so much?

13 votes
Accepted

Altium Designer - 45 degree rotation

13 votes
Accepted

what is the current limit through a trace?

11 votes
Accepted

Are transistors interchangeable?

11 votes
Accepted

PIC MCU: Software or hardware delay?

10 votes

Altium off sheet connector vs net vs ports

10 votes

Does current flow on an open transmission line?

10 votes
Accepted

Using NPN BJT with a P Channel MOSFET to switch 3.3V to 24V

9 votes

Is it always possible to reduce the number of layers on a PCB by making the board larger

8 votes
Accepted

Choosing an alternate resistor or capacitor in a circuit

8 votes
Accepted

Is it a good habit to route wire under chip resistor/capacitor?

8 votes
Accepted

How fast can a transistor switch?

8 votes

Transmission of a digital signal over a medium

8 votes
Accepted

What does this schematic of an Op-Amp and Capacitor mean?

8 votes
Accepted

Altium: Rules and Query syntax

8 votes
Accepted

What frequencies do capacitors filter?

8 votes

Choose a microcontroller

7 votes
Accepted

PCB Ground Pour, Crosstalk and antennas

7 votes

How do you change the default via dimensions in Altium?

6 votes

Do MOSFETs have voltage drop across source and drain when turned on?

6 votes
Accepted

UART without using the same clock

6 votes

How to shorten fall time on high-side BJT drive?

6 votes

Square wave -5 to +5 volt at 500 Hz

6 votes
Accepted

Altium - How do I place my GND vias?

5 votes
Accepted

Error in making pins input in PIC32

1
2 3 4 5 6