Toby Lawrence's user avatar
Toby Lawrence's user avatar
Toby Lawrence's user avatar
Toby Lawrence
  • Member for 11 years, 11 months
  • Last seen more than 10 years ago
13 votes

How to compare mAh and Wh

13 votes
Accepted

Solder Mask and Cream in Eagle

12 votes
Accepted

Decoupling caps with PICs

10 votes
Accepted

Automobile Project (Electrical Parts Requirement)

10 votes
Accepted

First time PCB design - board dimensions question

9 votes
Accepted

Eagle is refusing to tie ground pads of SMD components to the ground plane

8 votes
Accepted

Power supply design pattern with various capacitors

7 votes
Accepted

Soldering a wire to a small MOSFET pin

7 votes
Accepted

Is there a reason to use smps regulators over modules

6 votes
Accepted

LCD modules with I2C or SPI interface

6 votes
Accepted

PCB Design - Polygon pour remove islands or not?

5 votes
Accepted

eagle cad: enlarging the pads

5 votes
Accepted

How can I determine the peak power consumption of my office

5 votes

ADC registers setup using spi communication

3 votes
Accepted

How to detect when an antenna is not connected

3 votes

Need a device that can take single input and covert to a keyboard key press on USB

3 votes
Accepted

Measuring Arduino internal voltage reference with respect to Vcc

3 votes

Oscilloscope time base

3 votes

How to easily find or create parts for Eagle schematic/board layout

2 votes

Is CAN bus communications enough to update firmware?

2 votes
Accepted

Power management for a bus/self powered USB device

2 votes

How many capacitors are required 3.3 V rail for 500 mA?

2 votes

5V and +5v charger adapter, What is the difference?

2 votes

Solutions for implementing a USB Mass Storage Device

2 votes

How do I disable clearance check for a layer or for only some certain elements?

1 vote

5V-tolerant ARM

1 vote

what does "70A moy/arit 90A eff" on a high-current automotive lead-acid battery charger mean?

1 vote

Does anybody recognize this (other) automotive connector?

1 vote
Accepted

eagle cad - sharp edges

1 vote
Accepted

What are some good methods for adding charging control/signaling for a docking wireless system with a rechargeable battery?