Timeline for Max voltage for Arduino ATmega328 VCC pin (not raw!)
Current License: CC BY-SA 3.0
12 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| May 20, 2014 at 12:35 | vote | accept | Chris Drumgoole | ||
| Mar 30, 2014 at 6:42 | answer | added | KyranF | timeline score: 3 | |
| Mar 29, 2014 at 11:31 | comment | added | Chris Drumgoole | @PeterJ, thanks. i'll check on the regulator. i'd prefer to skip it as well. | |
| Mar 29, 2014 at 11:31 | vote | accept | Chris Drumgoole | ||
| May 20, 2014 at 12:35 | |||||
| Mar 29, 2014 at 10:11 | comment | added | PeterJ | @ChrisDrumgoole Answer below is correct on the microcontroller voltage. Not sure about that particular regulator (the MIC5205) but personally I'd remove it, some regulators can draw excessive current if a voltage is on the output without an input. | |
| Mar 29, 2014 at 9:01 | comment | added | Connor Wolf | That is the schematic for the arduino PCB, not the datasheet for the ATmega328P. That's not a datasheet, and not the relevant document anyways. | |
| Mar 29, 2014 at 8:31 | answer | added | Dejvid_no1 | timeline score: 9 | |
| Mar 29, 2014 at 7:54 | comment | added | Chris Drumgoole | Hi yes I did, (dlnmh9ip6v2uc.cloudfront.net/datasheets/Dev/Arduino/Boards/…) but they say the max voltage is 16V but I understand that is only to the RAW pin and not VCC. VCC, i have seen on some forums that you should give properly regulated voltage to VCC - so I am curious what the tolerance is for this pin for the 3.3v and 5v versions. thanks! | |
| Mar 29, 2014 at 5:06 | comment | added | Ignacio Vazquez-Abrams | It's right on the first page. Both important parts. | |
| Mar 29, 2014 at 5:04 | review | First posts | |||
| Mar 29, 2014 at 5:06 | |||||
| Mar 29, 2014 at 4:57 | comment | added | Matt Young | Have you looked at the datasheet? | |
| Mar 29, 2014 at 4:47 | history | asked | Chris Drumgoole | CC BY-SA 3.0 |