I wanted to check something I was working on, and it's an assignment so I don't want the answer, I just want to know if I am approaching it right.

I have an esaki diode. I have a curve (the s-curve that shows Voltage in vs. current. I am trying to figure out how to get 2 stable operating points, with a simple voltage source connected in series with a 250 ohm resistor. I know to calculate a load line, but for some reason I am not getting answers that make sense (I can't seem to get a lad line that intersects the curve that gets me two stable points unless my Vin is zero).

Any pointers? I am using the relation Vin = IdR + Vd, but I am not sure if that even applies here. I just want to see how to figure out how much voltage i need to bias the diode.

I wanted to check something I was working on, and it's an assignment so I don't want the answer, I just want to know if I am approaching it right.

I have an esaki diode. I have a curve (the s-curve that shows Voltage in vs. current. I am trying to figure out how to get 2 stable operating points, with a simple voltage source connected in series with a 250 ohm resistor. I know to calculate a load line, but for some reason I am not getting answers that make sense (I can't seem to get a lad line that intersects the curve that gets me two stable points unless my Vin is zero).

Any pointers? I am using the relation Vin = IdR + Vd, but I am not sure if that even applies here. I just want to see how to figure out how much voltage i need to bias the diode.

^{simulate this circuit – Schematic created using CircuitLab}

edited to add schematic