EDIT: The following figure shows Ozone debugger after target connection is initialized: When I single step, it jumps to a seemingly random address and then my binary does not execute properly if I let hit "Resume program execution". Perhaps that's related to the BLX instruction?

EDIT: The following figure shows Ozone debugger after target connection is initialized: When I single step, it jumps to a seemingly random address and then my binary does not execute properly if I hit "Resume program execution". Perhaps that's related to the BLX instruction shown above?

EDIT: The following figure shows Ozone debugger after target connection is initialized: When I single step, it jumps to a seemingly random address and then my binary does not execute properly if I let hit "Resume program execution". Perhaps that's related to the BLX instruction?

I performed some spot checks at memory locations (0x00, 0x100, 0x200, etc) and it matches the binary file. However, when I attempt to run the application, the processor jumps outside the application memory and does not run properly:

I performed some spot checks at memory offsets (0x00, 0x100, 0x200, etc) and it matches the binary file. However, when I attempt to run the application, the processor jumps outside the application memory and does not run properly: