Skip to main content
13 events
when toggle format what by license comment
Feb 10, 2019 at 9:02 comment added THEMuffinMan7 I don't see why you need a battery at all, you could just connect wires to your adc with a resistor on one end to simulate the input impedance of your sensor. That will tell you how much noise to expect. Ways you could improve that noise is to add termination resistors near your ADC, add ferries, shielding around your cabling, using a differential ADC & twisting your wires etc. This mostly assumes you are worried about induced noise and not system noise. Also, this might be a good read ni.com/white-paper/3344/en/#toc4
Feb 6, 2019 at 12:00 history tweeted twitter.com/StackElectronix/status/1093117266768642048
Feb 6, 2019 at 2:20 comment added Hot Licks The voltage across a battery is an analog signal, by any reasonable definition.
Feb 5, 2019 at 22:25 comment added Elliot Alderson You have already accepted an answer, but I think you should consider the issues that @dim brings up regarding the ADC.
Feb 5, 2019 at 22:06 answer added Voltage Spike timeline score: 1
Feb 5, 2019 at 21:46 history edited user211492 CC BY-SA 4.0
added 180 characters in body
Feb 5, 2019 at 21:05 comment added user211492 Very approximate modelling to start to get a basic understanding of what noise to expect. If it succeeds the initial testing I'll have to look into more elaborate approaches.
Feb 5, 2019 at 20:58 vote accept user211492
Feb 5, 2019 at 20:24 answer added Edgar Brown timeline score: 5
Feb 5, 2019 at 20:24 comment added Andy aka There are several models that each depend on what you are trying to accomplish.
Feb 5, 2019 at 20:24 answer added dim timeline score: 5
Feb 5, 2019 at 20:10 history edited user211492 CC BY-SA 4.0
added 63 characters in body
Feb 5, 2019 at 19:52 history asked user211492 CC BY-SA 4.0