I am designing a USB full speed board around the STM32F103xx MCU and was wondering how to physically position the 1.5 kΩ pull-up resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below. Thank you.
I am designing a USB full speed board around the STM32F103xx MCU and was wondering how to physically position the 1.5 kΩ pull-up resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below. Thank you.
I am designing a USB full speed board around the STM32F103xx MCU and was wondering how to physically position the 1.5 kΩ pull-up resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below.
I am designing a USB full speed board around the STM103XXSTM32F103xx MCU and was wondering how to physically position the 1.5K pullup5 kΩ pull-up resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below. Thank you.
I am designing a USB full speed board around the STM103XX MCU and was wondering how to physically position the 1.5K pullup resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below. Thank you.
I am designing a USB full speed board around the STM32F103xx MCU and was wondering how to physically position the 1.5 kΩ pull-up resistor on D+. Should it be next to the MCU or close to the receptacle or what? Does it even make a difference? I have attached a snapshot of the layout below. Thank you.
