Skip to main content
Electrical Engineering

Return to Question

Remove thanks / signature (not required on SE sites)
Source Link
PeterJ
PeterJ
  • 17.2k
  • 37
  • 57
  • 91

I am building a custom computer case into a 40mm grenade case however I am running into an issue with how to handle the DVI connections (Needneed two of them). Ideally I would like to use a circular connector however I cannot find any useful information online on how many pins are required for a DVI-D cable or how difficult this task will be.

Does anyone have any advice on how I could proceed with this task?

Thanks! Nate

I am building a custom computer case into a 40mm grenade case however I am running into an issue with how to handle the DVI connections (Need two of them). Ideally I would like to use a circular connector however I cannot find any useful information online on how many pins are required for a DVI-D cable or how difficult this task will be.

Does anyone have any advice on how I could proceed with this task?

Thanks! Nate

I am building a custom computer case into a 40mm grenade case however I am running into an issue with how to handle the DVI connections (need two of them). Ideally I would like to use a circular connector however I cannot find any useful information online on how many pins are required for a DVI-D cable or how difficult this task will be.

Does anyone have any advice on how I could proceed with this task?

Source Link
Nate Strandberg
Nate Strandberg
  • 11
  • 1

Circular DVI Connector

I am building a custom computer case into a 40mm grenade case however I am running into an issue with how to handle the DVI connections (Need two of them). Ideally I would like to use a circular connector however I cannot find any useful information online on how many pins are required for a DVI-D cable or how difficult this task will be.

Does anyone have any advice on how I could proceed with this task?

Thanks! Nate