Sparkfun's EL Escudo Dos breakout board uses this circuit for an EL wire driver channel, with R2 = R3 = 330.
I was wondering what the function of R2 and R3 is? Are they required? What would happen if they were simply replaced with a short?
EDIT: additional info
The HV lines are 110VAC and the channel will be driving EL tape (I think resistive and capacitive load?)
Sparkfun's EL Escudo Dos breakout board uses this circuit for an EL wire driver channel, with R2 = R3 = 330.
I was wondering what the function of R2 and R3 is? Are they required? What would happen if they were simply replaced with a short?
Sparkfun's EL Escudo Dos breakout board uses this circuit for an EL wire driver channel, with R2 = R3 = 330.
I was wondering what the function of R2 and R3 is? Are they required? What would happen if they were simply replaced with a short?
EDIT: additional info
The HV lines are 110VAC and the channel will be driving EL tape (I think resistive and capacitive load?)
Sparkfun's EL Escudo Dos breakout board uses this circuit for an EL wire driver channel, with R2 = R3 = 330.
I was wondering what the function of R2 and R3 is? Are they required? What would happen if they were simply replaced with a short?
