Skip to main content
Electrical Engineering

Return to Question

Cleaned up grammer, punctuation, captalization.
Source Link
JRE
JRE
  • 73.6k
  • 10
  • 112
  • 195

transistor Transistor as a heater device and measured by lm35LM35 temperature sensor?

theThe aim is to make tempa temperature control circuit using arduino unoan Arduino Uno as a controller  , lm35an LM35 sensor as feedback to measure the actual temptemperature, a TIP31cTIP31C transistor as actuator to control the power disspateddissipated (heat).and i) I have a 12V,1A power supply 12v,1a . note

Note: theThe transistor and sensor are near to each other  .

iI know that arduino unothe Arduino Uno should send pwmPWM through a resistor to the base of transistor . but, but what about collector and emitter  ? should i

Should I put 12v12V to the collector and gndground to the emitter  ? butBut that would mean a short circuit .

thank u .

transistor as a heater device and measured by lm35 temperature sensor?

the aim is to make temp control circuit using arduino uno as a controller  , lm35 sensor as feedback to measure the actual temp, a TIP31c transistor as actuator to control the power disspated (heat).and i have a power supply 12v,1a . note: the transistor and sensor are near to each other  .

i know that arduino uno should send pwm through resistor to base of transistor . but what about collector and emitter  ? should i put 12v to collector and gnd to emitter  ? but that mean short circuit .

thank u .

Transistor as a heater device and measured by LM35 temperature sensor?

The aim is to make a temperature control circuit using an Arduino Uno as a controller, an LM35 sensor as feedback to measure the actual temperature, a TIP31C transistor as actuator to control the power dissipated (heat.) I have a 12V,1A power supply.

Note: The transistor and sensor are near to each other.

I know that the Arduino Uno should send PWM through a resistor to the base of transistor, but what about collector and emitter?

Should I put 12V to the collector and ground to the emitter? But that would mean a short circuit.

Source Link
Tareq
Tareq
  • 15
  • 3

transistor as a heater device and measured by lm35 temperature sensor?

the aim is to make temp control circuit using arduino uno as a controller , lm35 sensor as feedback to measure the actual temp, a TIP31c transistor as actuator to control the power disspated (heat).and i have a power supply 12v,1a . note: the transistor and sensor are near to each other .

i know that arduino uno should send pwm through resistor to base of transistor . but what about collector and emitter ? should i put 12v to collector and gnd to emitter ? but that mean short circuit .

thank u .