Skip to main content
15 events
when toggle format what by license comment
Aug 4, 2022 at 5:02 history edited TonyDublov CC BY-SA 4.0
deleted 59 characters in body
S Aug 3, 2022 at 19:38 vote accept TonyDublov
Aug 3, 2022 at 16:59 history edited TonyDublov CC BY-SA 4.0
deleted 140 characters in body
Aug 3, 2022 at 11:52 comment added Antonio51 No worries. You should test the opamp alone.
Aug 3, 2022 at 7:11 comment added a concerned citizen @TonyDublov "Mildly related" was because, with a reversed polarity, the output signal will be a sum, instead of a difference, so you should get a larger signal to work with (given the small coupling and non-paired secondaries I presume you're dealing with physical limitations that should benefit from any improvement). Otherwise the selected answer does the job.
Aug 3, 2022 at 6:15 history edited TonyDublov CC BY-SA 4.0
added 116 characters in body
Aug 3, 2022 at 5:38 vote accept TonyDublov
S Aug 3, 2022 at 19:38
Aug 3, 2022 at 5:28 comment added TonyDublov @Antonio51I can't go into detail about the sensor. I chose the in-amp because of its high input impedance. A resistor would lower the input impedance and doesn't help in the simulation.
Aug 3, 2022 at 5:23 comment added TonyDublov @aconcernedcitizen It oscillates too.
Aug 2, 2022 at 21:34 history became hot network question
Aug 2, 2022 at 19:25 answer added Antonio51 timeline score: 2
Aug 2, 2022 at 19:17 comment added Antonio51 Why is the value of L6, a different value L8? NB: if the input transformer is "wideband", a resistor between the outputs (top L6, bottom L8) can lower the peak.
Aug 2, 2022 at 15:29 comment added a concerned citizen Mildly related: what happens if you switch the polarity of L8?
Aug 2, 2022 at 14:29 answer added Kevin White timeline score: 7
Aug 2, 2022 at 13:30 history asked TonyDublov CC BY-SA 4.0