I am using TCAN1043DRQ1 in my design.

May I know what are the layout guidelines I need to follow.

I checked the datasheet it.It does not say anything about layout guidelines. It tells more about protection  .

I have few questions.

1)What is the required trace width for signal lines(RXD,TXD,STB_N,EN,ERR_N,SPLIT)

2)What is the required trace width for supply lines.(VBAT,VCC,VIO)

3)I know the Z0 of can lines(CANH,CANL) is 120 ohm.May I know is there any width requirement.

I am using TCAN1043DRQ1 in my design.

May I know what are the layout guidelines I need to follow.

I checked the datasheet it. It does not say anything about layout guidelines. It tells more about protection.

I have few questions:

1. What is the required trace width for signal lines (RXD, TXD, STB_N, EN, ERR_N, SPLIT)?

2. What is the required trace width for supply lines (VBAT, VCC, VIO)?

3. I know the Z0 of can lines (CANH, CANL) is 120 ohm. May I know is there any width requirement?