Skip to main content
Electrical Engineering

Return to Question

clarify title
Link
joeforker
joeforker
  • 5.7k
  • 10
  • 41
  • 59

is Is a Crystalcrystal needed for burning firmware on AVR?

Corrected spacing and thanks
Source Link
Gustavo Litovsky
Gustavo Litovsky
  • 7.7k
  • 3
  • 27
  • 44

is a xtalCrystal needed for burning firmware

I want to program an AVR attiny2313 with my AVR ISP MKII

So I built a header that connects to a breadboard where I want to burn the firmware to the attinyATTiny via ISP,

so my question is,

I have a design that uses an external xtalCrystal of 16Mhxz16MHz

but I dontdon't have space on the actual protoboard for the ISP header, so can i upload the firmware with out a xtalCrystal [will configuration of fuses work?] and then use it the proper external xtalCrystal ?

Thanks!

is a xtal needed for burning firmware

I want to program an AVR attiny2313 with my AVR ISP MKII

So I built a header that connects to a breadboard where I want to burn the firmware to the attiny via ISP,

so my question is,

I have a design that uses an external xtal of 16Mhxz

but I dont have space on the actual protoboard for the ISP header, so can i upload the firmware with out a xtal [will configuration of fuses work?] and then use it the proper external xtal?

Thanks!

is a Crystal needed for burning firmware

I want to program an AVR attiny2313 with my AVR ISP MKII

So I built a header that connects to a breadboard where I want to burn the firmware to the ATTiny via ISP,

so my question is,

I have a design that uses an external Crystal of 16MHz

but I don't have space on the actual protoboard for the ISP header, so can i upload the firmware with out a Crystal [will configuration of fuses work?] and then use it the proper external Crystal ?

Source Link
manuelBetancurt
manuelBetancurt
  • 1.1k
  • 1
  • 10
  • 16

is a xtal needed for burning firmware

I want to program an AVR attiny2313 with my AVR ISP MKII

So I built a header that connects to a breadboard where I want to burn the firmware to the attiny via ISP,

so my question is,

I have a design that uses an external xtal of 16Mhxz

but I dont have space on the actual protoboard for the ISP header, so can i upload the firmware with out a xtal [will configuration of fuses work?] and then use it the proper external xtal?

Thanks!