All Questions
Tagged with parasitic-capacitance mosfet-driver
4 questions
1
vote
0
answers
115
views
MOSFET parasitic turn-on
I'm simulating a circuit which uses a high-voltage SiC N-channel FET to discharge a large voltage (something close to the breakdown voltage of the FET, 1.7 kV). The power supply for the circuit is a 1 ...
- 21
2
votes
2
answers
883
views
Wouldn't using two MOSFETs in push-pull configuration to drive a single MOSFET be counter-productive?
I'm trying to make a buck converter that uses a P-MOS for high-side switching using an STM32's PWM signal.
I can't figure out why it would be useful to drive the MOSFET using a push-pull MOSFET gate ...
- 633
0
votes
2
answers
147
views
MOSFET Controled Relay Problem
As a way to power-on/-off a circuit load, a MCU is used to drive a relay through two MOSFETs. The problem is, when the MCU GPIO output is measured 0-volt, the relay could stay connected.
Can anybody ...
- 555
4
votes
1
answer
800
views
MOSFET fast turn-off not enough
I have a PWM bridge driving a higher than 1k load from 200V supply. The simplified, equivalent schematic is this:
The drivers I'm using are slow turn-on/fast turn-off and, in the schematic, it's a 50%...
- 21.8k