Skip to main content

Questions tagged [shunt-regulator]

Filter by
Sorted by
Tagged with
3 votes
5 answers
664 views

Is this TL431 based low battery cutoff circuit practical

I made a low battery cutoff circuit to monitor my 12v lead acid battery using TL431. I followed the circuit diagram shown below. Sorry for the hand-drawn schematic. I am however not satisfied with the ...
sribasu's user avatar
  • 830
0 votes
1 answer
107 views

CS1237 ADC - series resistor of voltage reference too big?

I've recently tried multiple times to get consistent readings of a loadcell with a CS1237 ADC-module like the following: https://www.androegg.de/shop/cs1237-24-bit-adc-ad-konverter-modul-tl431/ It ...
Seppde's user avatar
  • 3
3 votes
5 answers
328 views

2-terminal shunt regulator design

We have retrofitted dimmable LED panels in our office spaces. These use a 0-10 Vdc control voltage. The control leads have an internal pull-up to about 10 Volts so that the panel runs at full ...
Dwayne Reid's user avatar
  • 24.1k
1 vote
2 answers
89 views

LM431 shunt regulator

I'm trying to figure out how to set R1 + R2 on the LM431 shunt regulator. I have input V+ that I can't change at 9 V and I want Vout at 5 V. What value of resistors should I use for that? How does the ...
Simplifier's user avatar
2 votes
0 answers
155 views

Shunt regulator for lithium battery protection

I was pestering this community with questions for a while now. The answers I've received were put into the circuit below. I've decided to post it here in case someone else is looking for this kind of ...
Maple's user avatar
  • 13.1k